lkml.org 
[lkml]   [2018]   [May]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [RFC] driver core: don't hold dev's parent lock when using async probe
On Thu, May 24, 2018 at 11:02:57AM -0400, Alan Stern wrote:
> On Thu, 24 May 2018, Martin Liu wrote:
>
> > On Tue, May 22, 2018 at 01:09:44PM -0400, Alan Stern wrote:
> > > On Tue, 22 May 2018, martin_liu wrote:
> > >
> > > > not sure if we still need 'bf74ad5bc417 ("[PATCH] Hold the
> > > > device's parent's lock during probe and remove")' since it has
> > > > been there over 10 years. If we still need it and hard to fix it
> > > > , the simple way is to find a place not to allow USB subsystem
> > > > drivers to have async probe capability. Any suggestion is welcome.
> > >
> > > I don't think the "allows_async_probing" attribute is the best way to
> > > attack this. Some other approach, like a special-purpose flag, might
> > > be better.
> > >
> > > Yes, USB still needs to have parent's locks held during probing.
> > > Here's the reason. A USB device can have multiple interfaces, each
> > > bound to its own driver. A driver may sometimes need to issue a reset,
> > > but in USB there's no way to reset a single interface. Only the entire
> > > device can be reset, and of course this affects all the interfaces.
> > > Therefore a driver needs to acquire the device lock before it can issue
> > > a reset.
> > >
> > > The problem is that the driver's thread may already hold the device
> > > lock. During a normal probe sequence, for example, the interfaces get
> > > probed by the hub driver while it owns the device lock. But for probes
> > > under other circumstances (for example, if the user writes to the
> > > driver's "bind" attribute in sysfs), the device lock might not be held.
> > >
> > > A driver cannot tell these two cases apart. The only way to make it
> > > work all the time is to have the caller _always_ hold the device lock
> > > while the driver is probed (or the removed, for that matter).
> > >
> > > Alan Stern
> >
> > Thanks for the reply and more detail about the backgroud. I'd like to
> > have a conclusion about it. Please kindly correct me if my understanding
> > is wrong. Regarding to the "special-purpose flag", do you mean we could
> > find a place in USB subsystem to have the flag set (not sure if it's
> > easy to find it). Driver core would be base on the flag to decide if we
> > need to hold the device's parent's lock.
>
> Yes, except that the flag would not be in the USB subsystem. It would
> be in the device, device_type, or bus_type structure, so that the
> driver core could access it.
>
> Alan Stern

Thanks for the quick feedback and the suggestion. will try to figure out how
it works.

Martin

\
 
 \ /
  Last update: 2018-05-24 18:06    [W:0.108 / U:5.824 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site