lkml.org 
[lkml]   [2018]   [May]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRE: [PATCH v10 1/2] cpufreq: Add Kryo CPU scaling driver
Date


> -----Original Message-----
> From: Sudeep Holla <sudeep.holla@arm.com>
> Sent: Wednesday, May 23, 2018 13:40
> To: Ilia Lin <ilialin@codeaurora.org>; vireshk@kernel.org; nm@ti.com;
> sboyd@kernel.org; robh@kernel.org; mark.rutland@arm.com;
> rjw@rjwysocki.net; linux-pm@vger.kernel.org; devicetree@vger.kernel.org;
> linux-kernel@vger.kernel.org
> Cc: Sudeep Holla <sudeep.holla@arm.com>
> Subject: Re: [PATCH v10 1/2] cpufreq: Add Kryo CPU scaling driver
>
>
>
> On 23/05/18 10:40, Ilia Lin wrote:
> > In Certain QCOM SoCs like apq8096 and msm8996 that have KRYO
> > processors, the CPU frequency subset and voltage value of each OPP
> > varies based on the silicon variant in use. Qualcomm Process Voltage
> > Scaling Tables defines the voltage and frequency value based on the
> > msm-id in SMEM and speedbin blown in the efuse combination.
> > The qcom-cpufreq-kryo driver reads the msm-id and efuse value from the
> > SoC to provide the OPP framework with required information.
> > This is used to determine the voltage and frequency value for each OPP
> > of
> > operating-points-v2 table when it is parsed by the OPP framework.
> >
> > Signed-off-by: Ilia Lin <ilialin@codeaurora.org>
>
> [...]
>
> > + pdev = platform_device_register_simple("cpufreq-dt", -1, NULL, 0);
> > + if (!IS_ERR(pdev))
> > + return 0;
> > +
> > + ret = PTR_ERR(pdev);
> > + dev_err(cpu_dev, "Failed to register platform device\n");
> > +
> > +free_opp:
> > + for_each_possible_cpu(cpu) {
> > + if (IS_ERR_OR_NULL(opp_tables[cpu]))
> > + break;
> > + dev_pm_opp_put_supported_hw(opp_tables[cpu]);
> > + }
> > +free_np:
> > + of_node_put(np);
> > +
> > + return ret;
> > +}
> > +late_initcall(qcom_cpufreq_kryo_driver_init);
>
> Any particular reason why this *has* to be late initcall ?
> Please change it to module_initcall otherwise.

The purpose is to give the cpufreq-dt the time to register the driver and only then my driver will add the platform device.

> Also address the of_node comments from Viresh.
>
> Otherwise, it looks good.
> --
> Regards,
> Sudeep

\
 
 \ /
  Last update: 2018-05-23 13:07    [W:0.061 / U:4.692 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site