lkml.org 
[lkml]   [2018]   [May]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v10 1/2] cpufreq: Add Kryo CPU scaling driver
From
Date


On 23/05/18 10:40, Ilia Lin wrote:
> In Certain QCOM SoCs like apq8096 and msm8996 that have KRYO processors,
> the CPU frequency subset and voltage value of each OPP varies
> based on the silicon variant in use. Qualcomm Process Voltage Scaling Tables
> defines the voltage and frequency value based on the msm-id in SMEM
> and speedbin blown in the efuse combination.
> The qcom-cpufreq-kryo driver reads the msm-id and efuse value from the SoC
> to provide the OPP framework with required information.
> This is used to determine the voltage and frequency value for each OPP of
> operating-points-v2 table when it is parsed by the OPP framework.
>
> Signed-off-by: Ilia Lin <ilialin@codeaurora.org>

[...]

> + pdev = platform_device_register_simple("cpufreq-dt", -1, NULL, 0);
> + if (!IS_ERR(pdev))
> + return 0;
> +
> + ret = PTR_ERR(pdev);
> + dev_err(cpu_dev, "Failed to register platform device\n");
> +
> +free_opp:
> + for_each_possible_cpu(cpu) {
> + if (IS_ERR_OR_NULL(opp_tables[cpu]))
> + break;
> + dev_pm_opp_put_supported_hw(opp_tables[cpu]);
> + }
> +free_np:
> + of_node_put(np);
> +
> + return ret;
> +}
> +late_initcall(qcom_cpufreq_kryo_driver_init);

Any particular reason why this *has* to be late initcall ?
Please change it to module_initcall otherwise.
Also address the of_node comments from Viresh.

Otherwise, it looks good.
--
Regards,
Sudeep

\
 
 \ /
  Last update: 2018-05-23 12:40    [W:0.069 / U:2.568 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site