[lkml]   [2018]   [May]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH v6] gpio: dwapb: Add support for 1 interrupt per port A GPIO
On Fri, May 11, 2018 at 10:31 AM, Phil Edworthy
<> wrote:

> The DesignWare GPIO IP can be configured for either 1 interrupt or 1
> per GPIO in port A, but the driver currently only supports 1 interrupt.
> See the DesignWare DW_apb_gpio Databook description of the
> 'GPIO_INTR_IO' parameter.
> This change allows the driver to work with up to 32 interrupts, it will
> get as many interrupts as specified in the DT 'interrupts' property.
> It doesn't do anything clever with the different interrupts, it just calls
> the same handler used for single interrupt hardware.
> Signed-off-by: Phil Edworthy <>
> Reviewed-by: Rob Herring <>
> Acked-by: Lee Jones <>
> ---
> One point to mention is that I have made it possible for users to have
> unconnected interrupts by specifying holes in the list of interrupts. This is
> done by supporting the interrupts-extended DT prop.
> However, I have no use for this and had to hack some test case for this.
> Perhaps the driver should support 1 interrupt or all GPIOa as interrupts?
> v6:
> - Treat DT and ACPI the same as much as possible. Note that we can't use
> platform_get_irq() to get the DT interrupts as they are in the port
> sub-node and hence do not have an associated platform device.

I already applied this patch in some version, can you check what is
in my devel branch and send incremental patches on top if
something needs changing?

Sorry for not knowing by heart what was applied or when, it's
just too much for me sometimes.

Linus Walleij

 \ /
  Last update: 2018-05-23 10:29    [W:0.112 / U:0.924 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site