lkml.org 
[lkml]   [2018]   [May]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH] net: ethernet: ti: cpsw: fix packet leaking in dual_mac mode
From
From: Grygorii Strashko <grygorii.strashko@ti.com>
Date: Tue, 1 May 2018 12:41:22 -0500

> In dual_mac mode packets arrived on one port should not be forwarded by
> switch hw to another port. Only Linux Host can forward packets between
> ports. The below test case (reported in [1]) shows that packet arrived on
> one port can be leaked to anoter (reproducible with dual port evms):
> - connect port 1 (eth0) to linux Host 0 and run tcpdump or Wireshark
> - connect port 2 (eth1) to linux Host 1 with vlan 1 configured
> - ping <IPx> from Host 1 through vlan 1 interface.
> ARP packets will be seen on Host 0.
>
> Issue happens because dual_mac mode is implemnted using two vlans: 1 (Port
> 1+Port 0) and 2 (Port 2+Port 0), so there are vlan records created for for
> each vlan. By default, the ALE will find valid vlan record in its table
> when vlan 1 tagged packet arrived on Port 2 and so forwards packet to all
> ports which are vlan 1 members (like Port.
>
> To avoid such behaviorr the ALE VLAN ID Ingress Check need to be enabled
> for each external CPSW port (ALE_PORTCTLn.VID_INGRESS_CHECK) so ALE will
> drop ingress packets if Rx port is not VLAN member.
>
> Signed-off-by: Grygorii Strashko <grygorii.strashko@ti.com>

Applied and queued up for -stable, thank you.

\
 
 \ /
  Last update: 2018-05-02 17:09    [W:0.115 / U:17.712 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site