lkml.org 
[lkml]   [2018]   [May]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
SubjectRe: [PATCH v1 3/5] arm64: dts: rockchip: Add gpio-syscon10 to rk3328
From
Date
On 10/05/18 10:16, djw@t-chip.com.cn wrote:
> From: Levin Du <djw@t-chip.com.cn>
>
> Adding a new gpio controller named "gpio-syscon10" to rk3328, providing
> access to the pins defined in the syscon GRF_SOC_CON10.

This is the GPIO_MUTE pin, right? The public TRM is rather vague, but
cross-referencing against the datasheet and schematics implies that it's
the "gpiomut_*" part of the GRF bit names which is most significant.

It might be worth using a more descriptive name here, since "syscon10"
is pretty much meaningless at the board level.

Robin.

> Boards using these special pins to control regulators or LEDs, can now
> utilize existing drivers like gpio-regulator and leds-gpio.
>
> Signed-off-by: Levin Du <djw@t-chip.com.cn>
>
> ---
>
> Changes in v1:
> - Split from V0 and add to rk3328.dtsi for general use.
>
> arch/arm64/boot/dts/rockchip/rk3328.dtsi | 6 ++++++
> 1 file changed, 6 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/rockchip/rk3328.dtsi b/arch/arm64/boot/dts/rockchip/rk3328.dtsi
> index b8e9da1..73a822d 100644
> --- a/arch/arm64/boot/dts/rockchip/rk3328.dtsi
> +++ b/arch/arm64/boot/dts/rockchip/rk3328.dtsi
> @@ -309,6 +309,12 @@
> mode-loader = <BOOT_BL_DOWNLOAD>;
> };
>
> + gpio_syscon10: gpio-syscon10 {
> + compatible = "rockchip,gpio-syscon";
> + gpio-controller;
> + #gpio-cells = <2>;
> + gpio,syscon-dev = <0 0x0428 0>;
> + };
> };
>
> uart0: serial@ff110000 {
>

\
 
 \ /
  Last update: 2018-05-10 14:51    [W:0.160 / U:0.092 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site