lkml.org 
[lkml]   [2018]   [May]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2 15/17] power: reset: mt6323: add a driver for MT6323 power controller
Hi,

On Wed, Apr 25, 2018 at 05:32:41PM +0800, sean.wang@mediatek.com wrote:
> From: Sean Wang <sean.wang@mediatek.com>
>
> The power device is responsible for externally down or up the power
> of the remote MediaTek SoC through the tiny circuit BBPU inside PMIC RTC.
>
> Though it's a part of RTC device, it would be better to be a standalone
> driver than to be a part of existent RTC driver so as to let us make
> concentration on works about power-controlling topic and to obtain
> improvements while the subsystem power/reset constantly growing.

I don't understand the above sentence. (I'm fine with adding the
driver)

> Currently, the most basic functionality supported is to just power off
> the system by writing to a special bit field in BBPU register after the
> system has reached pm_poweroff.
>
> Signed-off-by: Sean Wang <sean.wang@mediatek.com>
> ---
> drivers/power/reset/Kconfig | 10 ++++
> drivers/power/reset/Makefile | 1 +
> drivers/power/reset/mt6323-poweroff.c | 97 +++++++++++++++++++++++++++++++++++
> include/linux/mfd/mt6397/rtc.h | 1 +
> 4 files changed, 109 insertions(+)
> create mode 100644 drivers/power/reset/mt6323-poweroff.c
>
> diff --git a/drivers/power/reset/Kconfig b/drivers/power/reset/Kconfig
> index df58fc8..7b49d71 100644
> --- a/drivers/power/reset/Kconfig
> +++ b/drivers/power/reset/Kconfig
> @@ -128,6 +128,16 @@ config POWER_RESET_LTC2952
> This driver supports an external powerdown trigger and board power
> down via the LTC2952. Bindings are made in the device tree.
>
> +config POWER_RESET_MT6323
> + bool "MediaTek MT6323 power-off driver"
> + depends on MFD_MT6397
> + help
> + The power-off driver is responsible for externally shutdown down
> + the power of a remote MediaTek SoC MT6323 is connected to through
> + controlling a tiny circuit BBPU inside MT6323 RTC.
> +
> + Say Y if you have a board where MT6323 could be found.
> +
> config POWER_RESET_QNAP
> bool "QNAP power-off driver"
> depends on OF_GPIO && PLAT_ORION
> diff --git a/drivers/power/reset/Makefile b/drivers/power/reset/Makefile
> index 7778c74..8836172 100644
> --- a/drivers/power/reset/Makefile
> +++ b/drivers/power/reset/Makefile
> @@ -11,6 +11,7 @@ obj-$(CONFIG_POWER_RESET_GPIO) += gpio-poweroff.o
> obj-$(CONFIG_POWER_RESET_GPIO_RESTART) += gpio-restart.o
> obj-$(CONFIG_POWER_RESET_HISI) += hisi-reboot.o
> obj-$(CONFIG_POWER_RESET_MSM) += msm-poweroff.o
> +obj-$(CONFIG_POWER_RESET_MT6323) += mt6323-poweroff.o
> obj-$(CONFIG_POWER_RESET_OCELOT_RESET) += ocelot-reset.o
> obj-$(CONFIG_POWER_RESET_PIIX4_POWEROFF) += piix4-poweroff.o
> obj-$(CONFIG_POWER_RESET_LTC2952) += ltc2952-poweroff.o
> diff --git a/drivers/power/reset/mt6323-poweroff.c b/drivers/power/reset/mt6323-poweroff.c
> new file mode 100644
> index 0000000..c195766
> --- /dev/null
> +++ b/drivers/power/reset/mt6323-poweroff.c
> @@ -0,0 +1,97 @@
> +// SPDX-License-Identifier: GPL-2.0
> +/*
> + * Power off through MediaTek PMIC
> + *
> + * Copyright (C) 2018 MediaTek Inc.
> + *
> + * Author: Sean Wang <sean.wang@mediatek.com>
> + *
> + */
> +
> +#include <linux/err.h>
> +#include <linux/module.h>
> +#include <linux/of.h>

Not needed

> +#include <linux/platform_device.h>
> +#include <linux/mfd/mt6397/core.h>
> +#include <linux/mfd/mt6397/rtc.h>
> +
> +struct mt6323_pwrc {
> + struct device *dev;
> + struct regmap *regmap;
> + u32 base;
> +};
> +
> +static struct mt6323_pwrc *mt_pwrc;
> +
> +static void mt6323_do_pwroff(void)
> +{
> + struct mt6323_pwrc *pwrc = mt_pwrc;
> + unsigned int val;
> + int ret;
> +
> + regmap_write(pwrc->regmap, pwrc->base + RTC_BBPU, RTC_BBPU_KEY);
> + regmap_write(pwrc->regmap, pwrc->base + RTC_WRTGR, 1);
> +
> + ret = regmap_read_poll_timeout(pwrc->regmap,
> + pwrc->base + RTC_BBPU, val,
> + !(val & RTC_BBPU_CBUSY),
> + MTK_RTC_POLL_DELAY_US,
> + MTK_RTC_POLL_TIMEOUT);
> + if (ret)
> + dev_err(pwrc->dev, "failed to write BBPU: %d\n", ret);
> +
> + /* Wait some time until system down, otherwise, notice with a warn */
> + mdelay(1000);
> +
> + WARN_ONCE(1, "Unable to power off system\n");
> +}
> +
> +static int mt6323_pwrc_probe(struct platform_device *pdev)
> +{
> + struct mt6397_chip *mt6397_chip = dev_get_drvdata(pdev->dev.parent);
> + struct mt6323_pwrc *pwrc;
> + struct resource *res;
> +
> + pwrc = devm_kzalloc(&pdev->dev, sizeof(*pwrc), GFP_KERNEL);
> + if (!pwrc)
> + return -ENOMEM;
> +
> + res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
> + pwrc->base = res->start;
> + pwrc->regmap = mt6397_chip->regmap;
> + pwrc->dev = &pdev->dev;
> + mt_pwrc = pwrc;
> +
> + pm_power_off = &mt6323_do_pwroff;
> +
> + return 0;
> +}
> +
> +static int mt6323_pwrc_remove(struct platform_device *pdev)
> +{
> + if (pm_power_off == &mt6323_do_pwroff)
> + pm_power_off = NULL;
> +
> + return 0;
> +}
> +
> +static const struct of_device_id mt6323_pwrc_dt_match[] = {
> + { .compatible = "mediatek,mt6323-pwrc" },
> + {},
> +};
> +MODULE_DEVICE_TABLE(of, mt6323_pwrc_dt_match);

Don't forget to remove the DT table when you respin the series for
the requested binding changes.

> +static struct platform_driver mt6323_pwrc_driver = {
> + .probe = mt6323_pwrc_probe,
> + .remove = mt6323_pwrc_remove,
> + .driver = {
> + .name = "mt6323-pwrc",
> + .of_match_table = mt6323_pwrc_dt_match,
> + },
> +};
> +
> +module_platform_driver(mt6323_pwrc_driver);
> +
> +MODULE_DESCRIPTION("Poweroff driver for MT6323 PMIC");
> +MODULE_AUTHOR("Sean Wang <sean.wang@mediatek.com>");
> +MODULE_LICENSE("GPL v2");
> diff --git a/include/linux/mfd/mt6397/rtc.h b/include/linux/mfd/mt6397/rtc.h
> index 480977c..ac932c9 100644
> --- a/include/linux/mfd/mt6397/rtc.h
> +++ b/include/linux/mfd/mt6397/rtc.h
> @@ -16,6 +16,7 @@
>
> #define RTC_BBPU 0x0000
> #define RTC_BBPU_CBUSY BIT(6)
> +#define RTC_BBPU_KEY (0x43 << 8)
>
> #define RTC_WRTGR 0x003c

The driver looks fine otherwise.

-- Sebastian
[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2018-05-01 14:57    [W:0.136 / U:8.000 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site