lkml.org 
[lkml]   [2018]   [Apr]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: uart throughput
On Thu, Apr 05, 2018 at 10:08:14PM +0530, Muni Sekhar wrote:
> Hi All,
>
>
> I’ve an uart hardware implemented on Xilinx FPGA image and it connects
> to host CPU(Intel based chip) on PCIe bus in Linux platform.
>
>
> The following parameters were fixed or varied when measuring the UART
> throughput in internal loopback mode(UART_RX and UART_TX pins were
> internally connected):
>
>
> • Uart baud rate
> • Parity Bit
> • Stop Bit(s)
>
>
> The primary factor affecting UART throughput is the baud rate, apart
> from this any other factors affect the UART throughput?
>
> For 4000000 bps uart baud rate, what should be the theoretical peak
> data throughput?

Um, you do know what "baud rate" means, right? And how stop bits and
parity are related to a baud rate?

Throughput all depends on a whole raft of different things. How exactly
have you measured this and where did you find any performance
bottlenecks?

thanks,

greg k-h

\
 
 \ /
  Last update: 2018-04-05 21:20    [W:0.031 / U:2.304 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site