lkml.org 
[lkml]   [2018]   [Apr]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH v6 0/3] bcm2835: Add generic pinctrl support
Date
This series adds support for generic binding for pinctrl bcm2835 driver,
and add the code for set output buffer of a pin using the output-low and
output-high generic properties.

Tested on Raspberry Pi Zero W, based on bcm2835 SoC.

Changes since v5:
(Suggested by Stefan Wahren)
- Fix checkpatch warnings
- Use PIN_CONFIG_END+1 for bcm2835_pinconf_param for our pull legacy
configuration
(Suggested by Linus Walleij)
- Only resend patch 2+3
- Add Stephen Warren for subsequent postings

Changes since v4:
(Suggested by Rob Herring)
- Change dt-bindings docs driver reference to hardware in case the BCM2835
pin configuration and multiplexing

Changes since v3:
(Suggested by Stefan Wahren)
- Change dt-bindings docs patch order and subject

Changes since v2:
(Suggested by Eric Anholt)
- Remove PACK and UNPACK macros
- Use pinconf_to_config_* functions
(Suggested by Stefan Wahren)
- Fold Kconfig changes with the driver changes in a single patch
- Add devicetree bindings documentations about generic properties support
- Add devicetree bindings maintainers

Matheus Castello (2):
pinctrl: bcm2835: Add support for generic pinctrl binding
pinctrl: bcm2835: Add support for output-low output-high properties

drivers/pinctrl/bcm/Kconfig | 1 +
drivers/pinctrl/bcm/pinctrl-bcm2835.c | 100 +++++++++++++++++++++-------------
2 files changed, 64 insertions(+), 37 deletions(-)

--
2.7.4

\
 
 \ /
  Last update: 2018-04-29 21:55    [W:0.159 / U:4.756 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site