[lkml]   [2018]   [Apr]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Subject[PATCH v3 0/2] Add support for ov7251 camera sensor
The ov7251 sensor is a 1/7.5-Inch B&W VGA (640x480) CMOS Digital Image
Sensor from Omnivision.


Version 3:
- DT binding: added that there shall be a single endpoint node in the port node;
- added a comment for regulator enable order;
- set exposure and gain with a single i2c transaction;
- caclulate sleep after gpio config from external clock frequency;
- use MEDIA_BUS_FMT_Y10_1X10 format code;
- lock for power state, controls, mode and start streaming;
- remove regulator_set_voltage();
- use probe_new();
- remove i2c_device_id table;
- change of_property_read_u32 to fwnode_property_read_u32;
- few corrections from checkpatch --strict.


Version 2:
- changed ov7251 node's name in DT binding example;
- SPDX licence identifier;
- better names for register value defines;
- remove power reference counting and leave a power state only;
- use v4l2_find_nearest_size() to find sensor mode by requested size;
- set ycbcr_enc, quantization and xfer_func in set_fmt;
- use struct fwnode_handle instead of struct device_node;
- add comment in driver about external clock value.


Todor Tomov (2):
dt-bindings: media: Binding document for OV7251 camera sensor
media: Add a driver for the ov7251 camera sensor

.../devicetree/bindings/media/i2c/ov7251.txt | 52 +
drivers/media/i2c/Kconfig | 13 +
drivers/media/i2c/Makefile | 1 +
drivers/media/i2c/ov7251.c | 1501 ++++++++++++++++++++
4 files changed, 1567 insertions(+)
create mode 100644 Documentation/devicetree/bindings/media/i2c/ov7251.txt
create mode 100644 drivers/media/i2c/ov7251.c


 \ /
  Last update: 2018-04-24 17:02    [W:0.039 / U:2.012 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site