lkml.org 
[lkml]   [2018]   [Apr]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] mtd: nand: raw: atmel: add module param to avoid using dma
On Mon, 2 Apr 2018 22:23:17 +0200
Peter Rosin <peda@axentia.se> wrote:


> > I don't use devmem2. Is 'readback' information accurate or is it
> > always what's been written? Because when you write 0x33 to 0xFFFFECBC,
> > 0x33 is read back, but just after that, when you read it again it's 0.
>
> Looking at the devmem2 source, it seems very likely that the compiler
> optimizes out the read and thus outputs what has been written.

Yep, had a look too, and it's missing a volatile specifier to prevent
that sort of optimizations.

>
> >> BTW, how do I
> >> know which master is in use for the LCD controller? 8 or 9? Both?
> >
> > It's configurable on a per-layer basis through the SIF bit in
> > LCDC_<layer>CFG0. The driver tries to dispatch the load on those 2 AHB
> > masters [1].
>
> Ok, I only have one plane (in this case, i.e. no cursor, no overlays etc),
> would that mean that only one master is used?

Yep, it's always using the first one (master 8 on a sama5d3).

--
Boris Brezillon, Bootlin (formerly Free Electrons)
Embedded Linux and Kernel engineering
https://bootlin.com

\
 
 \ /
  Last update: 2018-04-02 22:36    [W:0.080 / U:3.520 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site