lkml.org 
[lkml]   [2018]   [Apr]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] mtd: nand: raw: atmel: add module param to avoid using dma
On Mon, 2 Apr 2018 22:20:20 +0200
Boris Brezillon <boris.brezillon@bootlin.com> wrote:

> >
> > > And
> > > which DDR slave is the target? 7, 8, 9 or 10? More than one?
> >
> > This, I don't know. I guess all of them can be used.
>
> Looks like I was wrong. According to "Table 15-3. SAMA5D3 Master to
> Slave Access", LCDC port 0 can only access DDR port 2 and LCDC port 1
> can only access DDR port 3.
>
> Can you try to write 0x3 to 0xFFFFECCC and 0x30 to 0xFFFFECD4?
>

Oh, one more thing. Changing the priority won't necessarily solve your
problem because of that:

"
If more than one master requests the slave bus, regardless of the
respective masters priorities, no master will be granted
the slave bus for two consecutive runs. A master can only get
back-to-back grants so long as it is the only requesting
master.
"

To solve that, you'll have to play with MATRIX_MCFGy.ULBT (make sure
DMAC0 and DMAC1 have a small enough ULBT that is not 0) or
MATRIX_SCFGx.SLOT_CYCLE (that one is probably harder to get right
since it's expressed in AHB clock cycles).

--
Boris Brezillon, Bootlin (formerly Free Electrons)
Embedded Linux and Kernel engineering
https://bootlin.com

\
 
 \ /
  Last update: 2018-04-02 22:33    [W:0.199 / U:0.404 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site