lkml.org 
[lkml]   [2018]   [Apr]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] gpio: zynq: Setup chip->base based on alias ID
Date
In past Xilinx gpio-zynq driver was setting up gpio chip->base as 0
which was chagned to autodetection when driver was upstreamed. Older
systems, which were using this old version, setup SW stack which expects
zynq gpio base as 0 and right now there is no way how to set this up.

The patch is adding an option to setup chip->base based on aliases which
is something what some other drivers are doing too.
It means when gpio0 alias is setup then chip->base is 0. When gpio alias
is not setup gpiochip_find_base() set it up properly which is current
behavior.

Signed-off-by: Michal Simek <michal.simek@xilinx.com>
---

drivers/gpio/gpio-zynq.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/gpio/gpio-zynq.c b/drivers/gpio/gpio-zynq.c
index 23bb10576def..412cb5f31a9b 100644
--- a/drivers/gpio/gpio-zynq.c
+++ b/drivers/gpio/gpio-zynq.c
@@ -831,7 +831,7 @@ static int zynq_gpio_probe(struct platform_device *pdev)
chip->free = zynq_gpio_free;
chip->direction_input = zynq_gpio_dir_in;
chip->direction_output = zynq_gpio_dir_out;
- chip->base = -1;
+ chip->base = of_alias_get_id(pdev->dev.of_node, "gpio");
chip->ngpio = gpio->p_data->ngpio;

/* Retrieve GPIO clock */
--
2.17.0
\
 
 \ /
  Last update: 2018-04-11 15:55    [W:0.350 / U:1.908 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site