[lkml]   [2018]   [Mar]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH v5 1/2] mfd: arizona: Update reset pin to use GPIOD
On Sat, Mar 24, 2018 at 03:32:05PM +0100, Linus Walleij wrote:
> On Mon, Mar 12, 2018 at 4:52 PM, Charles Keepax
> <> wrote:
> > Now GPIOD has support for both pdata systems and for non-standard DT
> > bindings the Arizona reset GPIO can be converted to use it. Worth
> > noting gpiod_set_raw_value_cansleep is used to match the behaviour
> > of the old GPIOs. This is because the part is fairly widely used and
> > it is unknown how many DTs are correctly setting active low through
> > device tree, so to avoid breaking any existing users it is best to
> > match the previous behaviour.
> >
> > Signed-off-by: Charles Keepax <>
> > ---
> The use of gpiod_set_raw* should be done with caution, but this
> is one of the cases where we need to take out the big hammer to
> make sure things stay compatible.
> I haven't read why it is like so but I guess because the right flags
> in the device tree can not be guaranteed?

Exactly yes there are a lot of these parts out there and since
they never required the DT flags to be set correctly before I
very much doubt all those DTs are set correctly.


 \ /
  Last update: 2018-03-26 10:34    [W:0.140 / U:0.392 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site