[lkml]   [2018]   [Mar]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH v2 00/13] Major code reorganization to make all i2c transfers working
On Mon, Mar 12, 2018 at 06:44:49PM +0530, Abhishek Sahu wrote:
> * v2:
> 1. Address review comments in v1
> 2. Changed the license to SPDX
> 3. Changed commit messages for some of the patch having more detail
> 4. Removed event-based completion and changed transfer completion
> detection logic in interrupt handler
> 5. Removed dma_threshold and blk_mode_threshold from global structure
> 6. Improved determine mode logic for QUP v2 transfers
> 7. Fixed function comments
> 8. Fixed auto build test WARNING ‘idx' may be used uninitialized
> in this function
> 9. Renamed tx/rx_buf to tx/rx_cnt
> * v1:
> The current driver is failing in following test case
> 1. Handling of failure cases is not working in long run for BAM
> mode. It generates error message “bam-dma-engine 7884000.dma: Cannot
> free busy channel” sometimes.
> 2. Following I2C transfers are failing
> a. Single transfer with multiple read messages
> b. Single transfer with multiple read/write message with maximum
> allowed length per message (65K) in BAM mode
> c. Single transfer with write greater than 32 bytes in QUP v1 and
> write greater than 64 bytes in QUP v2 for non-DMA mode.
> 3. No handling is present for Block/FIFO interrupts. Any non-error
> interrupts are being treated as the transfer completion and then
> polling is being done for available/free bytes in FIFO.
> To fix all these issues, major code changes are required. This patch
> series fixes all the above issues and makes the driver interrupt based
> instead of polling based. After these changes, all the mentioned test
> cases are working properly.
> The code changes have been tested for QUP v1 (IPQ8064) and QUP
> v2 (IPQ8074) with sample application written over i2c-dev.
> Abhishek Sahu (13):
> i2c: qup: fix copyrights and update to SPDX identifier
> i2c: qup: fixed releasing dma without flush operation completion
> i2c: qup: minor code reorganization for use_dma
> i2c: qup: remove redundant variables for BAM SG count
> i2c: qup: schedule EOT and FLUSH tags at the end of transfer
> i2c: qup: fix the transfer length for BAM RX EOT FLUSH tags
> i2c: qup: proper error handling for i2c error in BAM mode
> i2c: qup: use the complete transfer length to choose DMA mode
> i2c: qup: change completion timeout according to transfer length
> i2c: qup: fix buffer overflow for multiple msg of maximum xfer len
> i2c: qup: send NACK for last read sub transfers
> i2c: qup: reorganization of driver code to remove polling for qup v1
> i2c: qup: reorganization of driver code to remove polling for qup v2

Applied to for-next, thanks! Also thanks to the reviewers!

[unhandled content-type:application/pgp-signature]
 \ /
  Last update: 2018-03-24 13:22    [W:0.443 / U:0.092 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site