lkml.org 
[lkml]   [2018]   [Mar]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v5 2/3] dt-bindings: net: bluetooth: Add qualcomm-bluetooth
From
Date
Hi Thierry,

> Add binding document for serial bluetooth chips using Qualcomm protocol.
>
> Signed-off-by: Thierry Escande <thierry.escande@linaro.org>
> ---
>
> v5:
> - Rename 'bt-disable-n' gpio as 'enable'
>
> v4:
> - Move bt-disable-n-gpios to required properties section
> - Add clocks and pinctrl-0 as required properties
>
> v3: no change
> v2: no change
>
> .../devicetree/bindings/net/qualcomm-bluetooth.txt | 34 ++++++++++++++++++++++
> 1 file changed, 34 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/net/qualcomm-bluetooth.txt
>
> diff --git a/Documentation/devicetree/bindings/net/qualcomm-bluetooth.txt b/Documentation/devicetree/bindings/net/qualcomm-bluetooth.txt
> new file mode 100644
> index 000000000000..bbc2973634b2
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/net/qualcomm-bluetooth.txt
> @@ -0,0 +1,34 @@
> +Qualcomm Bluetooth Chips
> +---------------------
> +
> +This documents the binding structure and common properties for serial
> +attached Qualcomm devices.
> +
> +Serial attached Qualcomm devices shall be a child node of the host UART
> +device the slave device is attached to.
> +
> +Required properties:
> + - compatible: should contain one of the following:
> + * "qcom,qca6174-bt"
> + - enable-gpios: gpio specifier used to enable chip
> + - pinctrl-0: pin phandle for bt_en gpio
> + - clocks: clock phandle for SUSCLK_32KHZ

if I compare this with broadcom-bluetooth.txt or ti-bluetooth.txt then besides compatible, everything else is optional. The nokia-bluetooth.txt has everything required, but that is also a really specific platform.

Can we be less restrictive for a QCA general purpose chip?

> +
> +Example:
> +
> +serial@7570000 {
> + pinctrl-names = "default", "sleep";
> + pinctrl-0 = <&blsp1_uart1_default>;
> + pinctrl-1 = <&blsp1_uart1_sleep>;
> +
> + bluetooth {
> + compatible = "qcom,qca6174-bt";
> +
> + enable-gpios = <&pm8994_gpios 19 GPIO_ACTIVE_HIGH>;
> +
> + pinctrl-names = "default";
> + pinctrl-0 = <&bt_en_pin_a>;

This one I do not understand and you might want to shed some light into why this is done that way.

> +
> + clocks = <&divclk4>;

No clock-names?

Regards

Marcel

\
 
 \ /
  Last update: 2018-03-20 16:58    [W:0.113 / U:0.624 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site