[lkml]   [2018]   [Mar]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH v2] usb: dwc3: Prevent indefinite sleep in _dwc3_set_mode during suspend/resume

On 3/16/2018 3:03 PM, Roger Quadros wrote:
> On 16/03/18 13:00, Felipe Balbi wrote:
>> Hi,
>> Roger Quadros <> writes:
>>> Hi Felipe,
>>> On 09/03/18 14:47, Roger Quadros wrote:
>>>> In the following test we get stuck by sleeping forever in _dwc3_set_mode()
>>>> after which dual-role switching doesn't work.
>>>> On dra7-evm's dual-role port,
>>>> - Load g_zero gadget driver and enumerate to host
>>>> - suspend to mem
>>>> - disconnect USB cable to host and connect otg cable with Pen drive in it.
>>>> - resume system
>>>> - we sleep indefinitely in _dwc3_set_mode due to.
>>>> dwc3_gadget_exit()->usb_del_gadget_udc()->udc_stop()->
>>>> dwc3_gadget_stop()->wait_event_lock_irq()
>>>> To fix this instead of waiting indefinitely with wait_event_lock_irq()
>>>> we use wait_event_interruptible_lock_irq_timeout() and print
>>>> and error message if there was a timeout.
>>>> Signed-off-by: Roger Quadros <>
>>> Thanks for picking this for -next.
>>> Is it better to have this in v4.16-rc fixes?
>>> and also stable? v4.12+
>> Well, there was no "Fixes: foobar" or "Cc: stable" lines in the commit
>> log ;-)
>> The best we can do now, is wait for -rc1 and manually send the commit to
>> stable.
> That's fine. Thanks.

Same issue seen in dwc3_gadget_ep_dequeue() function where also used
wait_event_lock_irq() - as result infinite loop.
Actually to fix this issue I updated condition of wait function
Not, sure that this fix is fully correct because I'm familiar with dwc3,
but this fix allow us to go forward with request dequeue. I think, need
deeper investigation of infinite loop to catch root cause of it, before
accept any of fixes.


 \ /
  Last update: 2018-03-16 12:44    [W:0.093 / U:2.032 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site