lkml.org 
[lkml]   [2018]   [Mar]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 4/4] gpio: Remove VLA from stmpe driver
From
Date
On 03/13/2018 02:13 AM, Phil Reid wrote:
> On 10/03/2018 08:10, Laura Abbott wrote:
>> The new challenge is to remove VLAs from the kernel
>> (see https://lkml.org/lkml/2018/3/7/621)
>>
>> This patch replaces a VLA with an appropriate call to kmalloc_array.
>>
>> Signed-off-by: Laura Abbott <labbott@redhat.com>
>> ---
>>   drivers/gpio/gpio-stmpe.c | 7 ++++++-
>>   1 file changed, 6 insertions(+), 1 deletion(-)
>>
>> diff --git a/drivers/gpio/gpio-stmpe.c b/drivers/gpio/gpio-stmpe.c
>> index f8d7d1cd8488..b7854850bcdb 100644
>> --- a/drivers/gpio/gpio-stmpe.c
>> +++ b/drivers/gpio/gpio-stmpe.c
>> @@ -369,10 +369,14 @@ static irqreturn_t stmpe_gpio_irq(int irq, void *dev)
>>       struct stmpe *stmpe = stmpe_gpio->stmpe;
>>       u8 statmsbreg;
>>       int num_banks = DIV_ROUND_UP(stmpe->num_gpios, 8);
>> -    u8 status[num_banks];
>> +    u8 *status;
>>       int ret;
>>       int i;
>> +    status = kmalloc_array(num_banks, sizeof(*status), GFP_ATOMIC);
>> +    if (!status)
>> +        return IRQ_NONE;
>> +
>>       /*
>>        * the stmpe_block_read() call below, imposes to set statmsbreg
>>        * with the register located at the lowest address. As STMPE1600
>> @@ -424,6 +428,7 @@ static irqreturn_t stmpe_gpio_irq(int irq, void *dev)
>>           }
>>       }
>> +    kfree(status);
>>       return IRQ_HANDLED;
>>   }
>>
>
> Doing this in an irq handler seems wrong.
> Perhaps better if a buffer is pre-allocated in stmpe_gpio
>
>

Sure, I can pre-allocate the buffer in the probe.

Thanks,
Laura

\
 
 \ /
  Last update: 2018-03-14 01:18    [W:0.124 / U:0.968 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site