[lkml]   [2018]   [Feb]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH v12 7/9] ACPI: Translate the I/O range of non-MMIO devices before scanning
On Thu, Feb 1, 2018 at 1:32 PM, John Garry <> wrote:

I'm not going through all patch, by one thing I would like you to pay
attention on, i.e.
printing resource_size_t and struct resource

>> + dev_err(dev, "translate bus-addr(0x%llx) fail!\n",
>> + resource->start);

resource_size_t is dynamic width type, you will see a compiler
warning. For this we have
%pap specifier.

Moreover, in some cases it's useful to print struct resource via %pR or %pr.

Consider reading kernel documentation about these (printk-formats.rst).

>> +struct acpi_indirectio_host_data {
>> + resource_size_t io_size;
>> + resource_size_t io_start;
>> +};

Why not utilize struct resource?

If it's coming from platform / firmware it should *never* have types
like size_t, unsigned long, resource_size_t, etc.

>> +/* All the host devices which apply indirect-IO can be listed here. */
>> +static const struct acpi_device_id acpi_indirect_host_id[] = {
>> + {""},
>> +};

The idea of terminator is to be such (remove comma there). And it's
basically redundant to have an empty string there. Moreover, it's a
waste of resources in ro section.

With Best Regards,
Andy Shevchenko

 \ /
  Last update: 2018-02-05 14:16    [W:0.146 / U:47.008 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site