lkml.org 
[lkml]   [2018]   [Feb]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 4/4] i2c: xlp9xx: Check for Bus state after every transfer
From
Date
Hi Wolfram,

On 02/27/2018 02:34 PM, Wolfram Sang wrote:
> On Tue, Feb 27, 2018 at 10:30:31AM +0530, George Cherian wrote:
>> Hi Wolfram,
>>
>> Thanks for the review.
>>
>> On 02/27/2018 01:52 AM, Wolfram Sang wrote:
>>>
>>> On Thu, Jan 18, 2018 at 05:39:24AM +0000, George Cherian wrote:
>>>> I2C bus enters the STOP condition after the DATA_DONE interrupt is raised.
>>>> Essentially the driver should be checking the bus state before sending
>>>> the next transaction.
>>>
>>> Yes.
>>>
>>>> In case the next transaction is initiated while the
>>>> bus is busy, the prior transactions stop condition is not achieved.
>>>
>>> I didn't fully get why you can't check the BUSY bit and wait a little
>>> just before you push out the next message?
>> Yes, I am checking for the BUSY bit and looping.
>
> Yes, but *after* the STOP, not *before* the next message. I haven't
> fully understood why you don't do this before the next message is about
> to be sent. That might save you some busy looping, or?
Yes, Thanks for the clarification. You are right It is better to
check before next message. I will make required changes and post the patch.
>

Regards
-George

\
 
 \ /
  Last update: 2018-02-27 10:32    [W:0.055 / U:1.024 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site