lkml.org 
[lkml]   [2018]   [Feb]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 0/7] ARM: davinci: add genpd support
From
Date
On 02/09/2018 06:42 AM, Sekhar Nori wrote:
> Hi David,
>
> On Thursday 08 February 2018 04:13 AM, David Lechner wrote:
>> On 02/07/2018 07:45 AM, Bartosz Golaszewski wrote:
>>> From: Bartosz Golaszewski <bgolaszewski@baylibre.com>
>>>
>>> Hi Sekhar et al,
>>>
>>> please take a look at the following patches. They add a simple genpd
>>> driver and use it in DT mode on da850 boards.
>>>
>>> I was trying to use genpd in legacy mode too, but couldn't find neither
>>> any interfaces nor users that would do that. For now I added a check in
>>> arch/arm/mach-davinci/pm_domain.c that disables the clock pm setup if
>>> we're using genpd.
>>>
>>> This series applies on top of and has been tested with David Lechner's
>>> for-bartosz branch. It fixes the clock look-up issues we faced with
>>> lcdc and emac.
>>
>> I'm starting to think that it makes more sense to just make the PSC driver
>> a power-domain and reset provider rather than a clock provider. It is
>> unfortunate that genpd is DT only.
>
> This will mean that the only way to enable clocks on DaVinci is to use
> pm_runtime() calls. We do still have drivers which depend on clk api for
> enabling clocks, so I am not sure its feasible just yet.
>
> I think a question like this can arise for any gate clock.
>

I've incorporated parts of this series into my v7 work in progress
using the suggestions I made about using the existing PSC device
as the power domain provider.

\
 
 \ /
  Last update: 2018-02-18 04:41    [W:0.085 / U:1.296 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site