lkml.org 
[lkml]   [2018]   [Dec]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRE: [PATCH v4 1/7] spi: add support for octo mode I/O data transfer
Date
Hi Boris,

> -----Original Message-----
> From: Boris Brezillon [mailto:boris.brezillon@bootlin.com]
> Sent: Monday, December 3, 2018 1:35 PM
> To: Yogesh Narayan Gaur <yogeshnarayan.gaur@nxp.com>;
> broonie@kernel.org
> Cc: linux-mtd@lists.infradead.org; marek.vasut@gmail.com; vigneshr@ti.com;
> linux-spi@vger.kernel.org; devicetree@vger.kernel.org; robh@kernel.org;
> mark.rutland@arm.com; shawnguo@kernel.org; linux-arm-
> kernel@lists.infradead.org; computersforpeace@gmail.com;
> frieder.schrempf@exceet.de; linux-kernel@vger.kernel.org
> Subject: Re: [PATCH v4 1/7] spi: add support for octo mode I/O data transfer
>
> Hi Yogesh,
>
> On Thu, 22 Nov 2018 05:14:31 +0000
> Yogesh Narayan Gaur <yogeshnarayan.gaur@nxp.com> wrote:
>
> > Add flags for Octo mode I/O data transfer Required for the SPI
> > controller which can do the data transfer (TX/RX) on 8 data lines e.g.
> > NXP FlexSPI controller.
> > SPI_TX_OCTO: transmit with 8 wires
> > SPI_RX_OCTO: receive with 8 wires
> >
> > Signed-off-by: Yogesh Gaur <yogeshnarayan.gaur@nxp.com>
> > Reviewed-by: Boris Brezillon <boris.brezillon@bootlin.com>
> > ---
> > Changes for v4:
> > - Rebase on top of v4.20-rc2
> > Changes for v3:
> > - Modified string 'octal' with 'octo'.
>
> When I listed the differences between your version and mine, I mentioned the
> OCTO vs OCTAL name, but I didn't say my decision was the correct one :-). Looks
> like OCTAL is the term employed almost everywhere, and it's also consistent
> with DUAL. Would you mind sending a new version reverting the name to OCTAL.
>
Next version of patch series send [1]

--
Regards,
Yogesh Gaur
[1] https://patchwork.ozlabs.org/project/linux-mtd/list/?series=79338

[...]

\
 
 \ /
  Last update: 2018-12-03 09:49    [W:0.100 / U:1.984 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site