[lkml]   [2018]   [Dec]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH v4 10/10] KVM/x86/lbr: lazy save the guest lbr stack

Thanks. This looks a lot better than the earlier versions.

Some more comments.

On Wed, Dec 26, 2018 at 05:25:38PM +0800, Wei Wang wrote:
> When the vCPU is scheduled in:
> - if the lbr feature was used in the last vCPU time slice, set the lbr
> stack to be interceptible, so that the host can capture whether the
> lbr feature will be used in this time slice;
> - if the lbr feature wasn't used in the last vCPU time slice, disable
> the vCPU support of the guest lbr switching.

time slice is the time from exit to exit?

This might be rather short in some cases if the workload does a lot of exits
(which I would expect PMU workloads to do) Would be better to use some
explicit time check, or at least N exits.

> Upon the first access to one of the lbr related MSRs (since the vCPU was
> scheduled in):
> - record that the guest has used the lbr;
> - create a host perf event to help save/restore the guest lbr stack if
> the guest uses the user callstack mode lbr stack;

This is a bit risky. It would be safer (but also more expensive)
to always safe even for any guest LBR use independent of callstack.

Otherwise we might get into a situation where
a vCPU context switch inside the guest PMI will clear the LBRs
before they can be read in the PMI, so some LBR samples will be fully
or partially cleared. This would be user visible.

In theory could try to detect if the guest is inside a PMI and
save/restore then, but that would likely be complicated. I would
save/restore for all cases.

> +static void
> +__always_inline vmx_set_intercept_for_msr(unsigned long *msr_bitmap, u32 msr,
> + int type, bool value);

__always_inline should only be used if it's needed for functionality,
or in a header.

The rest looks good.


 \ /
  Last update: 2018-12-27 21:51    [W:0.155 / U:0.136 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site