lkml.org 
[lkml]   [2018]   [Dec]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2] pinctrl:mediatek:add judgment conditions
From
Date
On Sun, 2018-12-23 at 02:50 +0800, Sean Wang wrote:
> On Mon, Dec 17, 2018 at 6:32 PM <chuanjia.liu@mediatek.com> wrote:
> >
>
> I thought the subject still is much general, it should be further
> improved with something like "add EINT support to virtual GPIOs" and
> should say more about what virtual GPIOs means by MTKers in the patch
> description because "virtual" is a usual term used throughout the
> kernel and that would easily cause others to fail to interpret
> correctly.
>
Thank you for your advice,I will modify subject and description.
> > From: Chuanjia Liu <Chuanjia.Liu@mediatek.com>
> >
> > This patch avoid return err when virtual gpio set SMT.
> >
> > Signed-off-by: Chuanjia Liu <Chuanjia.Liu@mediatek.com>
> > ---
> > change note:
> > v2 : 1. delete virtual gpio number
> > 2. add judgment conditions
> > ---
> > drivers/pinctrl/mediatek/pinctrl-mtk-common-v2.c | 6 +++++-
> > 1 file changed, 5 insertions(+), 1 deletion(-)
> >
> > diff --git a/drivers/pinctrl/mediatek/pinctrl-mtk-common-v2.c b/drivers/pinctrl/mediatek/pinctrl-mtk-common-v2.c
> > index 4a9e0d4c2bbc..a576e417744a 100644
> > --- a/drivers/pinctrl/mediatek/pinctrl-mtk-common-v2.c
> > +++ b/drivers/pinctrl/mediatek/pinctrl-mtk-common-v2.c
> > @@ -290,7 +290,11 @@ static int mtk_xt_set_gpio_as_eint(void *data, unsigned long eint_n)
> > return err;
> >
> > err = mtk_hw_set_value(hw, desc, PINCTRL_PIN_REG_SMT, MTK_ENABLE);
> > - if (err)
> > +
> > + /* SMT doesn't support virtual GPIO, add err != -ENOTSUPP is used for
> > + * avoid return err when virtual gpio set SMT.
> > + */
>
> I'd prefer to the comments as the below
>
> /*
> SMT is supposed to be supported by every real GPIO and doesn't support
> virtual GPIOs, so the extra condition err != -ENOTSUPP is just for
> adding EINT support to these virtual GPIOs. It should add an extra
> flag in the pin descriptor when more pins with distinctive
> characteristic come out.
> */
>
Thank you for your advice,I will modify comments.
> > + if (err && err != -ENOTSUPP)
> > return err;
> >
> > return 0;
> > --
> > 2.19.1
> >


\
 
 \ /
  Last update: 2018-12-25 04:41    [W:0.072 / U:0.044 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site