lkml.org 
[lkml]   [2018]   [Dec]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 2/2] dt-bindings: edac: Aspeed AST2500
Date
From: Stefan M Schaeckeler <sschaeck@cisco.com>

Add support for the Aspeed AST2500 SoC EDAC driver.

Signed-off-by: Stefan M Schaeckeler <sschaeck@cisco.com>
---
.../bindings/edac/aspeed-sdram-edac.txt | 34 +++++++++++++++++++
1 file changed, 34 insertions(+)
create mode 100644 Documentation/devicetree/bindings/edac/aspeed-sdram-edac.txt

diff --git a/Documentation/devicetree/bindings/edac/aspeed-sdram-edac.txt b/Documentation/devicetree/bindings/edac/aspeed-sdram-edac.txt
new file mode 100644
index 000000000000..57ba852883c7
--- /dev/null
+++ b/Documentation/devicetree/bindings/edac/aspeed-sdram-edac.txt
@@ -0,0 +1,34 @@
+Aspeed AST2500 SoC EDAC device driver
+
+The Aspeed AST2500 SoC supports DDR3 and DDR4 memory with and without ECC (error
+correction check).
+
+The memory controller supports SECDED (single bit error correction, double bit
+error detection) and single bit error auto scrubbing by reserving 8 bits for
+every 64 bit word (effectively reducing available memory to 8/9).
+
+First, ECC must be configured in u-boot. Then, this driver will expose error
+counters via the edac kernel framework.
+
+A note on memory organization in ECC mode: every 512 bytes are followed by 64
+bytes of ECC codes. The address remapping is done in hardware and is fully
+transparent to firmware and software. Because of this, ECC mode must be
+configured in u-boot as part of the memory initialization as one can not switch
+from one mode to another when executing in memory.
+
+
+
+Required properties:
+- compatible: should be "aspeed,ast2500-sdram-edac"
+- reg: sdram controller register set should be <0x1e6e0000 0x174>
+- interrupts: should be AVIC interrupt #0
+
+
+Example:
+
+ edac: sdram@1e6e0000 {
+ compatible = "aspeed,ast2500-sdram-edac";
+ reg = <0x1e6e0000 0x174>;
+ interrupts = <0>;
+ status = "okay";
+ };
--
2.19.1
\
 
 \ /
  Last update: 2018-12-17 07:04    [W:0.116 / U:19.756 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site