lkml.org 
[lkml]   [2018]   [Nov]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 21/24] dt-bindings: leds-gpio: Add function and color properties
Date
Refer to new "function" and "color" properties and mark "label"
as deprecated.

Signed-off-by: Jacek Anaszewski <jacek.anaszewski@gmail.com>
Cc: Linus Walleij <linus.walleij@linaro.org>
---
.../devicetree/bindings/leds/leds-gpio.txt | 22 +++++++++++++++-------
1 file changed, 15 insertions(+), 7 deletions(-)

diff --git a/Documentation/devicetree/bindings/leds/leds-gpio.txt b/Documentation/devicetree/bindings/leds/leds-gpio.txt
index a48dda2..c34cb64 100644
--- a/Documentation/devicetree/bindings/leds/leds-gpio.txt
+++ b/Documentation/devicetree/bindings/leds/leds-gpio.txt
@@ -10,8 +10,12 @@ LED sub-node properties:
- gpios : Should specify the LED's GPIO, see "gpios property" in
Documentation/devicetree/bindings/gpio/gpio.txt. Active low LEDs should be
indicated using flags in the GPIO specifier.
-- label : (optional)
+- function : (optional)
+ see Documentation/devicetree/bindings/leds/common.txt
+- color : (optional)
see Documentation/devicetree/bindings/leds/common.txt
+- label : (optional)
+ see Documentation/devicetree/bindings/leds/common.txt (deprecated)
- linux,default-trigger : (optional)
see Documentation/devicetree/bindings/leds/common.txt
- default-state: (optional) The initial state of the LED.
@@ -30,27 +34,30 @@ Examples:

leds {
compatible = "gpio-leds";
- hdd {
- label = "Disk Activity";
+ led@0 {
gpios = <&mcu_pio 0 GPIO_ACTIVE_LOW>;
linux,default-trigger = "disk-activity";
+ function = LED_FUNCTION_HDD;
};

- fault {
+ led@1 {
gpios = <&mcu_pio 1 GPIO_ACTIVE_HIGH>;
/* Keep LED on if BIOS detected hardware fault */
default-state = "keep";
+ function = LED_FUNCTION_FAULT;
};
};

run-control {
compatible = "gpio-leds";
- red {
+ led@0 {
gpios = <&mpc8572 6 GPIO_ACTIVE_HIGH>;
+ color = "red";
default-state = "off";
};
- green {
+ led@1 {
gpios = <&mpc8572 7 GPIO_ACTIVE_HIGH>;
+ color = "green";
default-state = "on";
};
};
@@ -58,9 +65,10 @@ run-control {
leds {
compatible = "gpio-leds";

- charger-led {
+ led@0 {
gpios = <&gpio1 2 GPIO_ACTIVE_HIGH>;
linux,default-trigger = "max8903-charger-charging";
retain-state-suspended;
+ function = LED_FUNCTION_CHRG;
};
};
--
2.1.4
\
 
 \ /
  Last update: 2018-11-06 23:09    [W:0.219 / U:2.940 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site