[lkml]   [2018]   [Nov]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Subject[PATCH V2 0/4] spi: lpspi: Add Slave Mode support for LPSPI
Hi Mark,

i.MX LPSPI controller only works in Master mode previously. This patch
series adds support slave mode to LPSPI controller, including:
- Replace all related structure names and object names which is named
"master" with "controller",
- adds SPI slave mode support for i.MX7ulp and i.MX8qm/qxp in PIO mode,
- DT binding updates for slave mode.

Currently SPI Slave mode support patch has the following limitations:
1. The stale data in RXFIFO will be dropped when the Slave does any new
2. One transfer can be finished only after all transfer->len data been
transferred to master device
3. Slave device only accepts transfer->len data. Any data longer than this
from master device will be dropped. Any data shorter than this from
master will cause LPSPI to stuck due to mentioned limitation 2.
4. Only PIO transfer is supported in Slave Mode.

Wire connection:
GND, SCK, MISO(to MISO of slave), MOSI(to MOSI of slave), SCS

Change log:
- Split last version patch into 3 patches, and add the doc update.

Clark Wang (4):
spi: lpspi: Replace all "master" with "controller"
spi: lpspi: Add slave mode support
spi: lpspi: Let watermark change with send data length
doc: lpspi: Document DT bindings for LPSPI slave mode

.../devicetree/bindings/spi/spi-fsl-lpspi.txt | 5 +-
drivers/spi/spi-fsl-lpspi.c | 202 ++++++++++++------
2 files changed, 138 insertions(+), 69 deletions(-)


 \ /
  Last update: 2018-11-30 05:30    [W:0.105 / U:2.868 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site