[lkml]   [2018]   [Nov]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: Question about "regulator: core: Only count load for enabled consumers" in -next
On Sun, Nov 25, 2018 at 06:24:50PM -0500, Brian Masney wrote:
> On Sun, Nov 25, 2018 at 09:20:02AM -0800, Doug Anderson wrote:

> > I guess this is a workaround for drivers that don't set the load
> > properly themselves?

> I'm honestly not sure when the load should be set in the driver or in
> device tree. None of the drivers in drivers/mmc/ call
> regulator_set_load. The dt bindings describes the regulator-system-load
> property in Documentation/devicetree/bindings/regulator/regulator.txt.

Very few vendors disclose power numbers, ideally the drivers would be
providing power information especially if the load caused by the device
varies substantially at runtime (as is normal if things can go idle).
[unhandled content-type:application/pgp-signature]
 \ /
  Last update: 2018-11-26 13:51    [W:0.078 / U:25.048 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site