[lkml]   [2018]   [Nov]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [RCF PATCH,v2,2/2] pwm: imx: Configure output to GPIO in disabled state
Hello Michal,

On Thu, Nov 22, 2018 at 04:46:39PM +0000, Vokáč Michal wrote:
> On 22.11.2018 17:23, Uwe Kleine-König wrote:
> > On Thu, Nov 22, 2018 at 03:42:14PM +0000, Vokáč Michal wrote:
> >> On 16.11.2018 09:25, Uwe Kleine-König wrote:
> >>> On Fri, Nov 16, 2018 at 08:34:30AM +0100, Lothar Waßmann wrote:
> >>>> No. You can disable the output driver via pinctrl, so that only the
> >>>> selected pull-up/down is relevant. The pin function and GPIO register
> >>>> settings don't matter at all in this case.
> >>
> >> Lothar, please can you be more specific how would you do that? IFAIK the
> >> pull-up/down internal resistors have effect only if the pin is configured
> >> as GPIO *input* (on i.MX6 at least). See the TRM, Output driver:
> >>
> >> "Internal pull-up, pull-down resistors, and pad keeper are disabled in
> >> output mode."

This would mean you'd have to rely on an external pull up for your use
case. I wouldn't be surprised however if DSE=0 wouldn't count as "output
mode". Given the reliability of NXP documentation I wouldn't bet neither
on one nor the other possibility.

> > So I'd expect this to really work on i.MX6 but not the earlier SoCs
> > without a gpio specifier.
> Maybe you would expect it to work but I already tested and measured
> that weeks ago ;) It did not work.

Which pin/gpio do we talk about? Which i.MX6 variant did you test this
on? (Assuming i.MX6D or i.MX6Q and PAD_DISP0_DATA09, did you try setting

IOMUXC_SW_MUX_CTL_PAD_DISP0_DATA09 (0x020E0194) = 0x00000005
IOMUXC_SW_PAD_CTL_PAD_DISP0_DATA09 (0x020E04A8) = 0x0000b080

and then play with GPIO 4.30 direction and output value?)

Best regards

Pengutronix e.K. | Uwe Kleine-König |
Industrial Linux Solutions | |

 \ /
  Last update: 2018-11-22 20:04    [W:0.096 / U:0.024 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site