lkml.org 
[lkml]   [2018]   [Oct]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH V10 1/8] irqchip: add C-SKY SMP interrupt controller
Hi Marc,

On Mon, Oct 08, 2018 at 05:35:19PM +0100, Marc Zyngier wrote:
> Hi Guo,
>
> On 04/10/18 18:22, Guo Ren wrote:
> > - Irq-csky-mpintc is C-SKY smp system interrupt controller and it
> > could support 16 soft irqs, 16 private irqs, and 992 max common
> > irqs.
> >
> >Changelog:
> > - pass checkpatch.pl
> > - Move IPI_IRQ into the driver
> > - Remove irq_set_default_host() and use set_ipi_irq_mapping()

[...]

> >+#ifdef CONFIG_SMP
> >+static void csky_mpintc_send_ipi(const unsigned long *mask)
> >+{
>
> Why isn't this a cpumask? It should be this driver's job to convert the
> cpumask to an interrupt-controller specific representation, and not the SMP
> code's.
Ok, use cpumask.

[...]

> >+#ifdef CONFIG_SMP
> >+ set_send_ipi(&csky_mpintc_send_ipi);
> >+
> >+ set_ipi_irq_mapping(&csky_mpintc_ipi_irq_mapping);
>
> Since you seem to be inventing a new set_send_ipi callback, why don't you
> define it as:
>
> void set_send_ipi(void (*func)(const struct cpumask *),
> unsigned int ipi_irq);
> after having created the mapping for the IPI interrupt? It would avoid this
> rather pointless mapping callback.

I'll define it to:

void set_send_ipi(void (*func)(const struct cpumask *));

IPI_IRQ only use software-irq-15 in mpintc driver, so arch needn't care
about irq-num.

/*
* INTCL_SIGR[3:0] INTID
* INTCL_SIGR[8:15] CPUMASK
*/
writel_relaxed((*mask) << 8 | IPI_IRQ, reg_base + INTCL_SIGR);

We direct put IPI_IRQ to the hw-reg for the target core.

Best Regards
Guo Ren

\
 
 \ /
  Last update: 2018-10-09 04:25    [W:0.177 / U:0.696 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site