lkml.org 
[lkml]   [2018]   [Oct]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH net-next 1/2] net/ncsi: Add NCSI Broadcom OEM command
From
Date
On Fri, 2018-10-05 at 12:01 -0700, Vijay Khemka wrote:
> This patch adds OEM Broadcom commands and response handling. It also
> defines OEM Get MAC Address handler to get and configure the device.
>
> ncsi_oem_gma_handler_bcm: This handler send NCSI broadcom command for
> getting mac address.
> ncsi_rsp_handler_oem_bcm: This handles response received for all
> broadcom OEM commands.
> ncsi_rsp_handler_oem_bcm_gma: This handles get mac address response and
> set it to device.
>
> Signed-off-by: Vijay Khemka <vijaykhemka@fb.com>

Hi Vijay,

Looks good, and I've tested this on a BMC with a Broadcom network
controller and it properly sets a MAC address. A question below about the
response handler:

> ---
> net/ncsi/Kconfig | 6 ++++
> net/ncsi/internal.h | 8 +++++
> net/ncsi/ncsi-manage.c | 70 +++++++++++++++++++++++++++++++++++++++++-
> net/ncsi/ncsi-pkt.h | 8 +++++
> net/ncsi/ncsi-rsp.c | 42 ++++++++++++++++++++++++-
> 5 files changed, 132 insertions(+), 2 deletions(-)
>
> diff --git a/net/ncsi/Kconfig b/net/ncsi/Kconfig
> index 08a8a6031fd7..7f2b46108a24 100644
> --- a/net/ncsi/Kconfig
> +++ b/net/ncsi/Kconfig
> @@ -10,3 +10,9 @@ config NET_NCSI
> support. Enable this only if your system connects to a network
> device via NCSI and the ethernet driver you're using supports
> the protocol explicitly.
> +config NCSI_OEM_CMD_GET_MAC
> + bool "Get NCSI OEM MAC Address"
> + depends on NET_NCSI
> + ---help---
> + This allows to get MAC address from NCSI firmware and set them back to
> + controller.
> diff --git a/net/ncsi/internal.h b/net/ncsi/internal.h
> index 3d0a33b874f5..45883b32790e 100644
> --- a/net/ncsi/internal.h
> +++ b/net/ncsi/internal.h
> @@ -71,6 +71,13 @@ enum {
> /* OEM Vendor Manufacture ID */
> #define NCSI_OEM_MFR_MLX_ID 0x8119
> #define NCSI_OEM_MFR_BCM_ID 0x113d
> +/* Broadcom specific OEM Command */
> +#define NCSI_OEM_BCM_CMD_GMA 0x01 /* CMD ID for Get MAC */
> +/* OEM Command payload lengths*/
> +#define NCSI_OEM_BCM_CMD_GMA_LEN 12
> +/* Mac address offset in OEM response */
> +#define BCM_MAC_ADDR_OFFSET 28
> +
>
> struct ncsi_channel_version {
> u32 version; /* Supported BCD encoded NCSI version */
> @@ -240,6 +247,7 @@ enum {
> ncsi_dev_state_probe_dp,
> ncsi_dev_state_config_sp = 0x0301,
> ncsi_dev_state_config_cis,
> + ncsi_dev_state_config_oem_gma,
> ncsi_dev_state_config_clear_vids,
> ncsi_dev_state_config_svf,
> ncsi_dev_state_config_ev,
> diff --git a/net/ncsi/ncsi-manage.c b/net/ncsi/ncsi-manage.c
> index 091284760d21..e5bfd9245b5d 100644
> --- a/net/ncsi/ncsi-manage.c
> +++ b/net/ncsi/ncsi-manage.c
> @@ -635,6 +635,39 @@ static int set_one_vid(struct ncsi_dev_priv *ndp, struct ncsi_channel *nc,
> return 0;
> }
>
> +#if IS_ENABLED(CONFIG_NCSI_OEM_CMD_GET_MAC)
> +
> +/* NCSI OEM Command APIs */
> +static void ncsi_oem_gma_handler_bcm(struct ncsi_cmd_arg *nca)
> +{
> + int ret = 0;
> + unsigned char data[NCSI_OEM_BCM_CMD_GMA_LEN];
> +
> + nca->payload = NCSI_OEM_BCM_CMD_GMA_LEN;
> +
> + memset(data, 0, NCSI_OEM_BCM_CMD_GMA_LEN);
> + *(unsigned int *)data = ntohl(NCSI_OEM_MFR_BCM_ID);
> + data[5] = NCSI_OEM_BCM_CMD_GMA;
> +
> + nca->data = data;
> +
> + ret = ncsi_xmit_cmd(nca);
> + if (ret)
> + netdev_err(nca->ndp->ndev.dev,
> + "NCSI: Failed to transmit cmd 0x%x during configure\n",
> + nca->type);
> +}
> +
> +/* OEM Command handlers initialization */
> +static struct ncsi_oem_gma_handler {
> + unsigned int mfr_id;
> + void (*handler)(struct ncsi_cmd_arg *nca);
> +} ncsi_oem_gma_handlers[] = {
> + { NCSI_OEM_MFR_BCM_ID, ncsi_oem_gma_handler_bcm }
> +};
> +
> +#endif /* CONFIG_NCSI_OEM_CMD_GET_MAC */
> +
> static void ncsi_configure_channel(struct ncsi_dev_priv *ndp)
> {
> struct ncsi_dev *nd = &ndp->ndev;
> @@ -643,9 +676,10 @@ static void ncsi_configure_channel(struct ncsi_dev_priv *ndp)
> struct ncsi_channel *nc = ndp->active_channel;
> struct ncsi_channel *hot_nc = NULL;
> struct ncsi_cmd_arg nca;
> + struct ncsi_oem_gma_handler *nch = NULL;
> unsigned char index;
> unsigned long flags;
> - int ret;
> + int ret, i;
>
> nca.ndp = ndp;
> nca.req_flags = NCSI_REQ_FLAG_EVENT_DRIVEN;
> @@ -685,6 +719,40 @@ static void ncsi_configure_channel(struct ncsi_dev_priv *ndp)
> goto error;
> }
>
> +#if IS_ENABLED(CONFIG_NCSI_OEM_CMD_GET_MAC)
> + nd->state = ncsi_dev_state_config_oem_gma;
> + break;
> + case ncsi_dev_state_config_oem_gma:
> + nca.type = NCSI_PKT_CMD_OEM;
> + nca.package = np->id;
> + nca.channel = nc->id;
> + ndp->pending_req_num = 1;
> +
> + /* Check for manufacturer id and Find the handler */
> + for (i = 0; i < ARRAY_SIZE(ncsi_oem_gma_handlers); i++) {
> + if (ncsi_oem_gma_handlers[i].mfr_id ==
> + nc->version.mf_id) {
> + if (ncsi_oem_gma_handlers[i].handler)
> + nch = &ncsi_oem_gma_handlers[i];
> + else
> + nch = NULL;
> +
> + break;
> + }
> + }
> +
> + if (!nch) {
> + netdev_err(ndp->ndev.dev, "No handler available for GMA with MFR-ID (0x%x)\n",
> + nc->version.mf_id);
> + nd->state = ncsi_dev_state_config_clear_vids;
> + schedule_work(&ndp->work);
> + break;
> + }
> +
> + /* Get Mac address from NCSI device */
> + nch->handler(&nca);
> +#endif /* CONFIG_NCSI_OEM_CMD_GET_MAC */
> +
> nd->state = ncsi_dev_state_config_clear_vids;
> break;
> case ncsi_dev_state_config_clear_vids:
> diff --git a/net/ncsi/ncsi-pkt.h b/net/ncsi/ncsi-pkt.h
> index 0f2087c8d42a..4d3f06be38bd 100644
> --- a/net/ncsi/ncsi-pkt.h
> +++ b/net/ncsi/ncsi-pkt.h
> @@ -165,6 +165,14 @@ struct ncsi_rsp_oem_pkt {
> unsigned char data[]; /* Payload data */
> };
>
> +/* Broadcom Response Data */
> +struct ncsi_rsp_oem_bcm_pkt {
> + unsigned char ver; /* Payload Version */
> + unsigned char type; /* OEM Command type */
> + __be16 len; /* Payload Length */
> + unsigned char data[]; /* Cmd specific Data */
> +};
> +
> /* Get Link Status */
> struct ncsi_rsp_gls_pkt {
> struct ncsi_rsp_pkt_hdr rsp; /* Response header */
> diff --git a/net/ncsi/ncsi-rsp.c b/net/ncsi/ncsi-rsp.c
> index d66b34749027..bc20f7036579 100644
> --- a/net/ncsi/ncsi-rsp.c
> +++ b/net/ncsi/ncsi-rsp.c
> @@ -596,12 +596,52 @@ static int ncsi_rsp_handler_snfc(struct ncsi_request *nr)
> return 0;
> }
>
> +/* Response handler for Broadcom command Get Mac Address */
> +static int ncsi_rsp_handler_oem_bcm_gma(struct ncsi_request *nr)
> +{
> + struct ncsi_rsp_oem_pkt *rsp;
> + struct ncsi_dev_priv *ndp = nr->ndp;
> + struct net_device *ndev = ndp->ndev.dev;
> + int ret = 0;
> + const struct net_device_ops *ops = ndev->netdev_ops;
> + struct sockaddr saddr;
> +
> + /* Get the response header */
> + rsp = (struct ncsi_rsp_oem_pkt *)skb_network_header(nr->rsp);
> +
> + saddr.sa_family = ndev->type;
> + ndev->priv_flags |= IFF_LIVE_ADDR_CHANGE;
> + memcpy(saddr.sa_data, &rsp->data[BCM_MAC_ADDR_OFFSET], ETH_ALEN);
> + /* Increase mac address by 1 for BMC's address */
> + saddr.sa_data[ETH_ALEN - 1]++;

Is this convention documented somewhere, and could you provide a link to
it if so?

Also what happens here if the final byte of the address is 0xff, this
will overflow and not carry right?

> + ret = ops->ndo_set_mac_address(ndev, &saddr);
> + if (ret < 0)
> + netdev_warn(ndev, "NCSI: 'Writing mac address to device failed\n");

Also a minor nitpick, there's a bonus "'" in this message.

> +
> + return ret;
> +}
> +
> +/* Response handler for Broadcom card */
> +static int ncsi_rsp_handler_oem_bcm(struct ncsi_request *nr)
> +{
> + struct ncsi_rsp_oem_pkt *rsp;
> + struct ncsi_rsp_oem_bcm_pkt *bcm;
> +
> + /* Get the response header */
> + rsp = (struct ncsi_rsp_oem_pkt *)skb_network_header(nr->rsp);
> + bcm = (struct ncsi_rsp_oem_bcm_pkt *)(rsp->data);
> +
> + if (bcm->type == NCSI_OEM_BCM_CMD_GMA)
> + return ncsi_rsp_handler_oem_bcm_gma(nr);
> + return 0;
> +}
> +
> static struct ncsi_rsp_oem_handler {
> unsigned int mfr_id;
> int (*handler)(struct ncsi_request *nr);
> } ncsi_rsp_oem_handlers[] = {
> { NCSI_OEM_MFR_MLX_ID, NULL },
> - { NCSI_OEM_MFR_BCM_ID, NULL }
> + { NCSI_OEM_MFR_BCM_ID, ncsi_rsp_handler_oem_bcm }
> };
>
> /* Response handler for OEM command */


\
 
 \ /
  Last update: 2018-10-08 02:58    [W:2.041 / U:4.360 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site