lkml.org 
[lkml]   [2018]   [Oct]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH V2] clk: imx7d: remove UART1 clock setting
Date
There are clock assignments in all i.MX7D dtb files for UART1,
below is the example in imx7d-sdb.dts, so setting UART1 clock
in clock driver is NOT necessary, actually, module clocks setting
should be done in module driver.

&uart1 {
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_uart1>;
assigned-clocks = <&clks IMX7D_UART1_ROOT_SRC>;
assigned-clock-parents = <&clks IMX7D_PLL_SYS_MAIN_240M_CLK>;
status = "okay";
};

Signed-off-by: Anson Huang <Anson.Huang@nxp.com>
---
drivers/clk/imx/clk-imx7d.c | 3 ---
1 file changed, 3 deletions(-)

diff --git a/drivers/clk/imx/clk-imx7d.c b/drivers/clk/imx/clk-imx7d.c
index adb08f6..06c105d 100644
--- a/drivers/clk/imx/clk-imx7d.c
+++ b/drivers/clk/imx/clk-imx7d.c
@@ -886,9 +886,6 @@ static void __init imx7d_clocks_init(struct device_node *ccm_node)
/* use old gpt clk setting, gpt1 root clk must be twice as gpt counter freq */
clk_set_parent(clks[IMX7D_GPT1_ROOT_SRC], clks[IMX7D_OSC_24M_CLK]);

- /* set uart module clock's parent clock source that must be great then 80MHz */
- clk_set_parent(clks[IMX7D_UART1_ROOT_SRC], clks[IMX7D_OSC_24M_CLK]);
-
/* Set clock rate for USBPHY, the USB_PLL at CCM is from USBOTG2 */
clks[IMX7D_USB1_MAIN_480M_CLK] = imx_clk_fixed_factor("pll_usb1_main_clk", "osc", 20, 1);
clks[IMX7D_USB_MAIN_480M_CLK] = imx_clk_fixed_factor("pll_usb_main_clk", "osc", 20, 1);
--
2.7.4
\
 
 \ /
  Last update: 2018-10-19 03:07    [W:0.034 / U:1.016 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site