[lkml]   [2018]   [Oct]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH 09/11] dt-bindings: spi/spi-pxa2xx: Add ready GPIO signal
Hi Lubomir,

On Wed, Oct 10, 2018 at 7:10 PM Lubomir Rintel <> wrote:
> This this is used to let the SPI master know that our FIFO is filled and
> we're ready to service a transfer. Only useful in slave mode.
> A signal like this is used by an embedded controller on a OLPC XO 1.75
> machine, that happens to be a SPI master.
> Signed-off-by: Lubomir Rintel <>

Thanks for your patch!

> --- a/Documentation/devicetree/bindings/spi/spi-pxa2xx.txt
> +++ b/Documentation/devicetree/bindings/spi/spi-pxa2xx.txt
> @@ -12,6 +12,8 @@ Optional properties:
> - cs-gpios: list of GPIO chip selects. See the SPI bus bindings,
> Documentation/devicetree/bindings/spi/spi-bus.txt
> - spi-slave: Empty property indicating the SPI controller is used in slave mode.
> +- ready-gpio: GPIO used to signal a SPI master that the FIFO is filled


"GPIO properties named "[<name>-]gpio" are valid and old
bindings use it, but are only supported for compatibility reasons
and should not
be used for newer bindings since it has been deprecated."

> + and we're ready to service a transfer. Only useful in slave mode.
> Child nodes represent devices on the SPI bus
> See ../spi/spi-bus.txt



Geert Uytterhoeven -- There's lots of Linux beyond ia32 --

In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like that.
-- Linus Torvalds

 \ /
  Last update: 2018-10-11 09:27    [W:0.287 / U:6.000 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site