Messages in this thread |  | | Subject | Re: [PATCH v3] staging: dgnc: Fix Kconfig help header and text | From | Mark Hounschell <> | Date | Mon, 1 Oct 2018 08:09:48 -0400 |
| |
On 9/28/18 3:59 PM, Lidza Louina wrote: > I haven't done work on this driver in a long time. I looked up the > devices, and they seem to already have an existing Linux driver: > https://www.digi.com/products/usb-and-serial-connectivity/serial-cards/digineo and > https://www.digi.com/support/productdetail?pid=1694 > > I've contacted the company to see if the driver is still needed in > staging. I'll send an update once they get back to me. > > Lidza >
Good luck with that. Digi obsoleted ALL their PCI serial cards several months ago. They would not even respond to requests from me to include their firmware for their PCI dgap cards into the kernel firmware package. The card for the dgnc driver is a pci-e card that may still be supported by them however. Also there does appear to be an already in kernel driver for these "PCI-e" cards too. It actually works as I have a couple of these cards. The module name is "jsm".
03:00.0 Serial controller: Digi International Device 00f0 (rev 02) (prog-if 02 [16550]) Subsystem: Digi International Device 00f0 Control: I/O- Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx- Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx- Interrupt: pin A routed to IRQ 29 Region 0: Memory at f7200000 (32-bit, non-prefetchable) [size=4K] Capabilities: [40] Power Management version 2 Flags: PMEClk+ DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot+,D3cold-) Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME- Kernel driver in use: jsm Kernel modules: jsm
Regards Mark
|  |