Messages in this thread |  | | Subject | Re: [PATCH v3 0/6] arm: sunxi: IR support for A83T | From | Philipp Rossak <> | Date | Tue, 9 Jan 2018 09:02:43 +0100 |
| |
On 05.01.2018 15:59, Maxime Ripard wrote: > Hi, > > On Fri, Jan 05, 2018 at 12:02:53PM +0000, Sean Young wrote: >> On Tue, Dec 19, 2017 at 09:07:41AM +0100, Philipp Rossak wrote: >>> This patch series adds support for the sunxi A83T ir module and enhances >>> the sunxi-ir driver. Right now the base clock frequency for the ir driver >>> is a hard coded define and is set to 8 MHz. >>> This works for the most common ir receivers. On the Sinovoip Bananapi M3 >>> the ir receiver needs, a 3 MHz base clock frequency to work without >>> problems with this driver. >>> >>> This patch series adds support for an optinal property that makes it able >>> to override the default base clock frequency and enables the ir interface >>> on the a83t and the Bananapi M3. >>> >>> changes since v2: >>> * reorder cir pin (alphabetical) >>> * fix typo in documentation >>> >>> changes since v1: >>> * fix typos, reword Documentation >>> * initialize 'b_clk_freq' to 'SUNXI_IR_BASE_CLK' & remove if statement >>> * change dev_info() to dev_dbg() >>> * change naming to cir* in dts/dtsi >>> * Added acked Ackedi-by to related patch >>> * use whole memory block instead of registers needed + fix for h3/h5 >>> >>> changes since rfc: >>> * The property is now optinal. If the property is not available in >>> the dtb the driver uses the default base clock frequency. >>> * the driver prints out the the selected base clock frequency. >>> * changed devicetree property from base-clk-frequency to clock-frequency >>> >>> Regards, >>> Philipp >>> >>> >>> Philipp Rossak (6): >>> media: rc: update sunxi-ir driver to get base clock frequency from >>> devicetree >>> media: dt: bindings: Update binding documentation for sunxi IR >>> controller >>> arm: dts: sun8i: a83t: Add the cir pin for the A83T >>> arm: dts: sun8i: a83t: Add support for the cir interface >>> arm: dts: sun8i: a83t: bananapi-m3: Enable IR controller >>> arm: dts: sun8i: h3-h8: ir register size should be the whole memory >>> block >> >> I can take this series (through rc-core, i.e. linux-media), but I need an >> maintainer Acked-by: for the sun[x8]i dts changes (all four patches). > > We'll merge them through our tree. We usually have a rather big number > of patches around, so we'd be better off avoiding conflicts :) > > Philipp, can you resubmit the DTs as soon as -rc1 is out? > > Thanks! > Maxime > Yes, I can do this!
Regards, Philipp
|  |