[lkml]   [2018]   [Jan]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH v2 3/3] gpio: rcar: Use WAKEUP_PATH driver PM flag
On Fri, Dec 29, 2017 at 2:31 PM, Ulf Hansson <> wrote:

> From: Geert Uytterhoeven <>
> Since commit ab82fa7da4dce5c7 ("gpio: rcar: Prevent module clock disable
> when wake-up is enabled"), when a GPIO is used for wakeup, the GPIO block's
> module clock (if exists) is manually kept running during system suspend, to
> make sure the device stays active.
> However, this explicit clock handling is merely a workaround for a failure
> to properly communicate wakeup information to the PM core. Instead, set the
> WAKEUP_PATH driver PM flag to indicate that the device is part of the
> wakeup path, which further also enables middle-layers and PM domains (like
> genpd) to act on this.
> In case the device is attached to genpd and depending on if it has an
> active wakeup configuration, genpd will keep the device active (the clock
> running) during system suspend when needed. This enables us to remove all
> explicit clock handling code from the driver, so let's do that as well.
> Signed-off-by: Geert Uytterhoeven <>
> [Ulf: Converted to use the WAKEUP_PATH driver PM flag]
> Signed-off-by: Ulf Hansson <>

Acked-by: Linus Walleij <>

I guess it is dependent on the other patches?

If you want me to just apply it to the GPIO tree, tell me.

Linus Walleij

 \ /
  Last update: 2018-01-02 10:27    [W:0.172 / U:0.096 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site