[lkml]   [2017]   [Sep]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Patch in this message
Subject[PATCH 1/2] dt-bindings: spi: Add Spreadtrum ADI controller documentation
This patch adds the binding documentation for Spreadtrum ADI
controller device.

Signed-off-by: Baolin Wang <>
.../devicetree/bindings/spi/spi-sprd-adi.txt | 44 ++++++++++++++++++++
1 file changed, 44 insertions(+)
create mode 100644 Documentation/devicetree/bindings/spi/spi-sprd-adi.txt

diff --git a/Documentation/devicetree/bindings/spi/spi-sprd-adi.txt b/Documentation/devicetree/bindings/spi/spi-sprd-adi.txt
new file mode 100644
index 0000000..11c5259
--- /dev/null
+++ b/Documentation/devicetree/bindings/spi/spi-sprd-adi.txt
@@ -0,0 +1,44 @@
+Spreadtrum ADI controller based on SPI framework
+ADI is the abbreviation of Anolog-Digital interface, which is used to access
+analog chip (such as PMIC) from digital chip. ADI controller follows the SPI
+framework for its hardware implementation is alike to SPI bus and its timing
+is compatile to SPI timing.
+ADI controller has 50 channels including 2 software read/write channels and
+48 hardware channels to access analog chip. For hardware channels, we introduce
+one property named "sprd,hw-channels" to configure hardware channels, the first
+value specifies the channel id, and the second value specifies the address which
+is mapped into analog chip space.
+Since we have multi-subsystems will use ADI to access analog chip, then we need
+one hardware spinlock to synchronize between the multiple subsystems.
+Required properties:
+- compatible: Should be "sprd,sc9860-adi".
+- reg: Offset and length of ADI-SPI controller register space.
+- hwlocks: Reference to a phandle of a hwlock provider node.
+- hwlock-names: Reference to hwlock name strings defined in the same order
+ as the hwlocks.
+- #address-cells: Number of cells required to define a chip select address
+ on the ADI-SPI bus. Should be set to 1.
+- #size-cells: Size of cells required to define a chip select address size
+ on the ADI-SPI bus. Should be set to 0.
+Optional properties:
+- sprd,hw-channels: Specify the hardware channel number and mapped address
+ for hardware channel accessing.
+SPI slave nodes must be children of the SPI controller node and can contain
+properties described in Documentation/devicetree/bindings/spi/spi-bus.txt.
+ adi_bus: spi@40030000 {
+ compatible = "sprd,sc9860-adi";
+ reg = <0 0x40030000 0 0x10000>;
+ hwlocks = <&hwlock1 0>;
+ hwlock-names = "adi";
+ #address-cells = <1>;
+ #size-cells = <0>;
+ sprd,hw-channels = <30 0x8c20>;
+ };
 \ /
  Last update: 2017-09-06 08:17    [W:0.417 / U:0.008 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site