[lkml]   [2017]   [Sep]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Patch in this message
Subject[PATCH review for 4.4 10/47] extcon: axp288: Use vbus-valid instead of -present to determine cable presence
From: Hans de Goede <>

[ Upstream commit 5757aca10146061befd168dab37fb0db1ccd8f73 ]

The vbus-present bit in the power status register also gets set to 1
when a usb-host cable (id-pin shorted to ground) is plugged in and a 5v
boost converter is supplying 5v to the otg usb bus.

This causes a "disconnect or unknown or ID event" warning in dmesg as
well as the extcon device to report the last detected charger cable
type as being connected even though none is connected.

This commit switches to checking the vbus-valid bit instead, which is
only 1 when both vbus is present and the vbus-path is enabled in the
vbus-path control register (the vbus-path gets disabled when a usb-host
cable is detected, to avoid the pmic drawing power from the 5v boost

Signed-off-by: Hans de Goede <>
Acked-by: Chanwoo Choi <>
Signed-off-by: Chanwoo Choi <>
Signed-off-by: Sasha Levin <>
drivers/extcon/extcon-axp288.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/extcon/extcon-axp288.c b/drivers/extcon/extcon-axp288.c
index fd55c2f2080a..6c9d7ccebb8c 100644
--- a/drivers/extcon/extcon-axp288.c
+++ b/drivers/extcon/extcon-axp288.c
@@ -168,7 +168,7 @@ static int axp288_handle_chrg_det_event(struct axp288_extcon_info *info)
return ret;

- vbus_attach = (pwr_stat & PS_STAT_VBUS_PRESENT);
+ vbus_attach = (pwr_stat & PS_STAT_VBUS_VALID);
if (!vbus_attach)
goto notify_otg;

 \ /
  Last update: 2017-09-20 06:54    [W:0.174 / U:0.044 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site