lkml.org 
[lkml]   [2017]   [Aug]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 2/2] gpio: 74x164: handling enable-gpios
Date
To 74hc595 and 74lv595, there is an OE(low active) input pin.
To some boards, this pin is controller by GPIO, so handling
this pin in driver. When driver probe, use GPIOD_OUT_LOW flag
when requesting the gpio, so OE is set to low when probe.

Signed-off-by: Peng Fan <peng.fan@nxp.com>
Cc: Linus Walleij <linus.walleij@linaro.org>
---
drivers/gpio/gpio-74x164.c | 9 +++++++++
1 file changed, 9 insertions(+)

diff --git a/drivers/gpio/gpio-74x164.c b/drivers/gpio/gpio-74x164.c
index a6607fa..e44422c 100644
--- a/drivers/gpio/gpio-74x164.c
+++ b/drivers/gpio/gpio-74x164.c
@@ -23,6 +23,7 @@ struct gen_74x164_chip {
struct gpio_chip gpio_chip;
struct mutex lock;
u32 registers;
+ struct gpio_desc *enable_gpio;
/*
* Since the registers are chained, every byte sent will make
* the previous byte shift to the next register in the
@@ -142,6 +143,12 @@ static int gen_74x164_probe(struct spi_device *spi)
chip->gpio_chip.parent = &spi->dev;
chip->gpio_chip.owner = THIS_MODULE;

+ chip->enable_gpio = devm_gpiod_get(&spi->dev, "enable", GPIOD_OUT_LOW);
+ if (IS_ERR(chip->enable_gpio)) {
+ dev_dbg(&spi->dev, "No enable-gpios property\n");
+ chip->enable_gpio = NULL;
+ }
+
mutex_init(&chip->lock);

ret = __gen_74x164_write_config(chip);
@@ -164,6 +171,8 @@ static int gen_74x164_remove(struct spi_device *spi)
{
struct gen_74x164_chip *chip = spi_get_drvdata(spi);

+ if (chip->enable_gpio)
+ gpiod_set_value(chip->enable_gpio, 0);
gpiochip_remove(&chip->gpio_chip);
mutex_destroy(&chip->lock);

--
2.6.6
\
 
 \ /
  Last update: 2017-08-07 14:28    [W:0.045 / U:5.576 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site