[lkml]   [2017]   [Aug]   [31]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Subject[RFC PATCH 0/6] Add platform device SVM support for ARM SMMUv3
Jean-Philippe has post a patchset for Adding PCIe SVM support to ARM SMMUv3:

But for some platform devices(aka on-chip integrated devices), there is also
SVM requirement, which works based on the SMMU stall mode.
Jean-Philippe has prepared a prototype patchset to support it:
git:// svm/stall

We tested this patchset with some fixes on a on-chip integrated device. The
basic function is ok, so I just send them out for review, although this
patchset heavily depends on the former patchset (PCIe SVM support for ARM
SMMUv3), which is still under discussion.

Patch Overview:
*1 to 3 prepare for device tree or acpi get the device stall ability and pasid bits
*4 is to realise the SVM function for platform device
*5 is fix a bug when test SVM function while SMMU donnot support this feature
*6 avoid ILLEGAL setting of STE and CD entry about stall

Acctually here, I also have a question about SVM on SMMUv3:

1. Why the SVM feature on SMMUv3 depends on BTM feature? when bind a task to device,
it will register a mmu_notify. Therefore, when a page range is invalid, we can
send TLBI or ATC invalid without BTM?

2. According to ACPI IORT spec, named component specific data has a node flags field
whoes bit0 is for Stall support. However, it do not have any field for pasid bit.
Can we use other 5 bits[5:1] for pasid bit numbers, so we can have 32 pasid bit for
a single platform device which should be enough, because SMMU only support 20 bit pasid

3. Presently, the pasid is allocate for a task but not for a context, if a task is trying
to bind to 2 device A and B:
a) A support 5 pasid bits
b) B support 2 pasid bits
c) when the task bind to device A, it allocate pasid = 16
d) then it must be fail when trying to bind to task B, for its highest pasid is 4.
So it should allocate a single pasid for a context to avoid this?

Jean-Philippe Brucker (3):
dt-bindings: document stall and PASID properties for IOMMU masters
iommu/of: Add stall and pasid properties to iommu_fwspec
iommu/arm-smmu-v3: Add SVM support for platform devices

Yisheng Xie (3):
ACPI: IORT: Add stall and pasid properties to iommu_fwspec
iommu/arm-smmu-v3: fix panic when handle stall mode irq
iommu/arm-smmu-v3: Avoid ILLEGAL setting of STE.S1STALLD and CD.S

Documentation/devicetree/bindings/iommu/iommu.txt | 13 ++
drivers/acpi/arm64/iort.c | 20 ++
drivers/iommu/arm-smmu-v3.c | 230 ++++++++++++++++++----
drivers/iommu/of_iommu.c | 11 +
include/acpi/actbl2.h | 5 +
include/linux/iommu.h | 2 +
6 files changed, 244 insertions(+), 37 deletions(-)


 \ /
  Last update: 2017-08-31 10:31    [W:0.199 / U:1.432 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site