lkml.org 
[lkml]   [2017]   [Jul]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH v7 0/6] g_NCR5380: PDMA fixes and cleanup
Date
Ondrej, would you please test this new series?

Changed since v1:
- PDMA transfer residual is calculated earlier.
- End of DMA flag check is now polled (if there is any residual).

Changed since v2:
- Bail out of transfer loops when Gated IRQ gets asserted.
- Make udelay conditional on board type.
- Drop sg_tablesize patch due to performance regression.

Changed since v3:
- Add Ondrej's workaround for corrupt WRITE commands on DTC boards.
- Reset the 53c400 logic after any short PDMA transfer.
- Don't fail the transfer if the 53c400 logic got a reset.

Changed since v4:
- Bail out of transfer loops when Gated IRQ gets asserted. (Again.)
- Always call wait_for_53c80_registers() at end of transfer.
- Drain chip buffers after PDMA receive is interrupted.
- Rework residual calculation.
- Add new patch to correct DMA terminology.

Changed since v5:
- Rework residual calculation to account for on-chip buffer swap.
- Attempt to retain the disconnect/IRQ detection in the DTC436 workaround.
- Move all DTC436 workarounds to final patch.

Changed since v6:
- Fix residual calculation for the buffer timeout case.
- Iterate after sending final 128 bytes to check for buffer timeout.
- Don't log the residual value when it is known to be zero.


Finn Thain (2):
g_NCR5380: Cleanup comments and whitespace
g_NCR5380: Use unambiguous terminology for PDMA send and receive

Ondrej Zary (4):
g_NCR5380: Fix PDMA transfer size
g_NCR5380: End PDMA transfer correctly on target disconnection
g_NCR5380: Re-work PDMA loops
g_NCR5380: Two DTC436 PDMA workarounds

drivers/scsi/g_NCR5380.c | 277 ++++++++++++++++++++++++++---------------------
1 file changed, 155 insertions(+), 122 deletions(-)

--
2.13.0

\
 
 \ /
  Last update: 2017-07-03 10:02    [W:0.056 / U:3.808 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site