lkml.org 
[lkml]   [2017]   [May]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH 8/8] serial: exar: Add support for IOT2040 device
On Sat, May 13, 2017 at 10:29 AM, Jan Kiszka <jan.kiszka@siemens.com> wrote:
> This implements the setup of RS232 and the switch-over to RS485 or RS422
> for the Siemens IOT2040. That uses an EXAR XR17V352 with external logic
> to switch between the different modes. The external logic is controlled
> via MPIO pins of the EXAR controller.
>
> Only pin 10 can be exported as GPIO on the IOT2040. It is connected to
> an LED.
>
> As the XR17V352 used on the IOT2040 is not equipped with an external
> EEPROM, it cannot present itself as IOT2040-variant via subvendor/
> subdevice IDs. Thus, we have to check via DMI for the target platform.
>
> Co-developed with Sascha Weisenberger.
>

Please, refactor that using properly formed DMI structrure and use its
callback and driver data facilities/

stmmac's pattern that you obviously applied does not actually suit here.

--
With Best Regards,
Andy Shevchenko

\
 
 \ /
  Last update: 2017-05-13 15:55    [W:0.424 / U:0.092 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site