lkml.org 
[lkml]   [2017]   [May]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 6/8] serial: uapi: Add support for bus termination
Date
The Siemens IOT2040 comes with a RS485 interface that allows to enable
or disable bus termination via software. Add a bit to the flags field of
serial_rs485 that applications can set in order to request this feature
from the hardware. This seems generic enough to add it for everyone.
Existing driver will simply ignore it when set.

Signed-off-by: Sascha Weisenberger <sascha.weisenberger@siemens.com>
Signed-off-by: Jan Kiszka <jan.kiszka@siemens.com>
---
include/uapi/linux/serial.h | 3 +++
1 file changed, 3 insertions(+)

diff --git a/include/uapi/linux/serial.h b/include/uapi/linux/serial.h
index 5d59c3ebf459..d2667ecd54ac 100644
--- a/include/uapi/linux/serial.h
+++ b/include/uapi/linux/serial.h
@@ -122,6 +122,9 @@ struct serial_rs485 {
#define SER_RS485_RTS_AFTER_SEND (1 << 2) /* Logical level for
RTS pin after sent*/
#define SER_RS485_RX_DURING_TX (1 << 4)
+#define SER_RS485_TERMINATE_BUS (1 << 5) /* Enable bus
+ termination
+ (if supported) */
__u32 delay_rts_before_send; /* Delay before send (milliseconds) */
__u32 delay_rts_after_send; /* Delay after send (milliseconds) */
__u32 padding[5]; /* Memory is cheap, new structs
--
2.12.0
\
 
 \ /
  Last update: 2017-05-13 09:32    [W:0.111 / U:0.760 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site