Messages in this thread |  | | From | Rob Herring <> | Date | Mon, 1 May 2017 22:01:50 -0500 | Subject | Re: [PATCH v2 3/4] iio: accel: adxl345: Setup DATA_READY trigger |
| |
On Sun, Apr 30, 2017 at 7:32 PM, Jonathan Cameron <jic23@kernel.org> wrote: > On 29/04/17 08:49, Eva Rachel Retuya wrote: >> The ADXL345 provides a DATA_READY interrupt function to signal >> availability of new data. This interrupt function is latched and can be >> cleared by reading the data registers. The polarity is set to active >> high by default. >> >> Support this functionality by setting it up as an IIO trigger. >> >> In addition, two output pins INT1 and INT2 are available for driving >> interrupts. Allow mapping to either pins by specifying the >> interrupt-names property in device tree. >> >> Signed-off-by: Eva Rachel Retuya <eraretuya@gmail.com> > Coming together nicely, but a few more bits and pieces inline... > > One slight worry is that the irq names stuff is to restrictive > as we want to direct different interrupts to different pins if > both are supported!
[...]
>> @@ -199,6 +253,22 @@ int adxl345_core_probe(struct device *dev, struct regmap *regmap, >> dev_err(dev, "Failed to set data range: %d\n", ret); >> return ret; >> } >> + /* >> + * Any bits set to 0 send their respective interrupts to the INT1 pin, >> + * whereas bits set to 1 send their respective interrupts to the INT2 >> + * pin. Map all interrupts to the specified pin. > This is an interesting comment. The usual reason for dual interrupt > pins is precisely to not map all functions to the same one. That allows > for a saving in querying which interrupt it is by having just the data ready > on one pin and just the events on the other... > > Perhaps the current approach won't support that mode of operation? > Clearly we can't merge a binding that enforces them all being the same > and then change it later as it'll be incompatible. > > I'm not quite sure how one should do this sort of stuff in DT though. > > Rob?
DT should just describe what is connected which I gather here could be either one or both IRQs. We generally distinguish the IRQs with the interrupt-names property and then retrieve it as below.
>> + */ >> + of_irq = of_irq_get_byname(dev->of_node, "INT2"); >> + if (of_irq == irq) >> + regval = 0xFF; >> + else >> + regval = 0x00;
|  |