[lkml]   [2017]   [Nov]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH] wcn36xx: Set BTLE coexistence related configuration values to defaults
Ramon Fried <> writes:

> From: Eyal Ilsar <>
> If the value for the firmware configuration parameters
> BTC_STATIC_LEN_LE_BT and BTC_STATIC_LEN_LE_WLAN are not set the duty
> cycle between BT and WLAN is such that if BT (including BLE) is active
> WLAN gets 0 bandwidth. When tuning these parameters having a too high
> value for WLAN means that BLE performance degrades. The "sweet" point
> of roughly half of the maximal values was empirically found to achieve
> a balance between BLE and Wi-Fi coexistence performance.
> Signed-off-by: Eyal Ilsar <>
> Signed-off-by: Ramon Fried <>

Then submit a new version of the patch then please include the version

So after fixing Bjorn's comments the next version should be v3.

Kalle Valo

 \ /
  Last update: 2017-11-14 07:55    [W:0.088 / U:0.184 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site