Messages in this thread Patch in this message |  | | From | Bryan O'Donoghue <> | Subject | [PATCH v2 3/7] nvmem: imx-ocotp: Add support for banked OTP addressing | Date | Sun, 8 Oct 2017 23:41:18 +0100 |
| |
The i.MX7S/D takes the bank address in the CTRLn.ADDR field and the data value in one of the DATAx {0, 1, 2, 3} register fields. The current write routine is based on writing the CTRLn.ADDR field and writing a single DATA register only.
Fixes: 0642bac7da42 ("nvmem: imx-ocotp: add write support")
Signed-off-by: Bryan O'Donoghue <pure.logic@nexus-software.ie> --- drivers/nvmem/imx-ocotp.c | 72 ++++++++++++++++++++++++++++++++++++++++------- 1 file changed, 62 insertions(+), 10 deletions(-)
diff --git a/drivers/nvmem/imx-ocotp.c b/drivers/nvmem/imx-ocotp.c index 7798571..3b18351 100644 --- a/drivers/nvmem/imx-ocotp.c +++ b/drivers/nvmem/imx-ocotp.c @@ -40,7 +40,10 @@ #define IMX_OCOTP_ADDR_CTRL_SET 0x0004 #define IMX_OCOTP_ADDR_CTRL_CLR 0x0008 #define IMX_OCOTP_ADDR_TIMING 0x0010 -#define IMX_OCOTP_ADDR_DATA 0x0020 +#define IMX_OCOTP_ADDR_DATA0 0x0020 +#define IMX_OCOTP_ADDR_DATA1 0x0030 +#define IMX_OCOTP_ADDR_DATA2 0x0040 +#define IMX_OCOTP_ADDR_DATA3 0x0050 #define IMX_OCOTP_BM_CTRL_ADDR 0x0000007F #define IMX_OCOTP_BM_CTRL_BUSY 0x00000100 @@ -55,6 +58,7 @@ static DEFINE_MUTEX(ocotp_mutex); struct ocotp_params { unsigned int nregs; + unsigned int bank_address_words; }; struct ocotp_priv { @@ -176,6 +180,7 @@ static int imx_ocotp_write(void *context, unsigned int offset, void *val, u32 timing = 0; u32 ctrl; u8 waddr; + u8 word = 0; /* allow only writing one complete OTP word at a time */ if ((bytes != priv->config->word_size) || @@ -228,8 +233,22 @@ static int imx_ocotp_write(void *context, unsigned int offset, void *val, * description. Both the unlock code and address can be written in the * same operation. */ - /* OTP write/read address specifies one of 128 word address locations */ - waddr = offset / 4; + if (priv->params->bank_address_words != 0) { + /* + * In banked mode the OTP register bank goes into waddr see + * i.MX 7Solo Applications Processor Reference Manual, Rev. 0.1 + * 6.4.3.1 + */ + offset = offset / priv->config->word_size; + waddr = offset / priv->params->bank_address_words; + word = offset & (priv->params->bank_address_words - 1); + } else { + /* + * OTP write/read address specifies one of 128 word address + * locations + */ + waddr = offset / 4; + } ctrl = readl(priv->base + IMX_OCOTP_ADDR_CTRL); ctrl &= ~IMX_OCOTP_BM_CTRL_ADDR; @@ -255,8 +274,41 @@ static int imx_ocotp_write(void *context, unsigned int offset, void *val, * shift right (with zero fill). This shifting is required to program * the OTP serially. During the write operation, HW_OCOTP_DATA cannot be * modified. + * Note: on i.MX7 there are four data fields to write for banked write + * with the fuse blowing operation only taking place after data0 + * has been written. This is why data0 must always be the last + * register written. */ - writel(*buf, priv->base + IMX_OCOTP_ADDR_DATA); + if (priv->params->bank_address_words == 0) { + writel(*buf, priv->base + IMX_OCOTP_ADDR_DATA0); + } else { + switch (word) { + case 0: + writel(0, priv->base + IMX_OCOTP_ADDR_DATA1); + writel(0, priv->base + IMX_OCOTP_ADDR_DATA2); + writel(0, priv->base + IMX_OCOTP_ADDR_DATA3); + writel(*buf, priv->base + IMX_OCOTP_ADDR_DATA0); + break; + case 1: + writel(*buf, priv->base + IMX_OCOTP_ADDR_DATA1); + writel(0, priv->base + IMX_OCOTP_ADDR_DATA2); + writel(0, priv->base + IMX_OCOTP_ADDR_DATA3); + writel(0, priv->base + IMX_OCOTP_ADDR_DATA0); + break; + case 2: + writel(0, priv->base + IMX_OCOTP_ADDR_DATA1); + writel(*buf, priv->base + IMX_OCOTP_ADDR_DATA2); + writel(0, priv->base + IMX_OCOTP_ADDR_DATA3); + writel(0, priv->base + IMX_OCOTP_ADDR_DATA0); + break; + case 3: + writel(0, priv->base + IMX_OCOTP_ADDR_DATA1); + writel(0, priv->base + IMX_OCOTP_ADDR_DATA2); + writel(*buf, priv->base + IMX_OCOTP_ADDR_DATA3); + writel(0, priv->base + IMX_OCOTP_ADDR_DATA0); + break; + } + } /* 47.4.1.4.5 * Once complete, the controller will clear BUSY. A write request to a @@ -312,12 +364,12 @@ static struct nvmem_config imx_ocotp_nvmem_config = { .reg_write = imx_ocotp_write, }; -static const struct ocotp_params params[] = { - { .nregs = 128 }, - { .nregs = 64 }, - { .nregs = 128 }, - { .nregs = 128 }, - { .nregs = 64 }, +static const struct octop_params params[] = { + { .nregs = 128, .bank_address_words = 0 }, + { .nregs = 64, .bank_address_words = 0 }, + { .nregs = 128, .bank_address_words = 0 }, + { .nregs = 128, .bank_address_words = 0 }, + { .nregs = 64, .bank_address_words = 4 }, }; static const struct of_device_id imx_ocotp_dt_ids[] = { -- 2.7.4
|  |