lkml.org 
[lkml]   [2016]   [Aug]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: musb: am3358: having problem with high-speed on usb1 at peripheral
From
Date


On 08/16/2016 04:31 PM, Felipe Balbi wrote:
> Hi,
>
> Ayaka <ayaka@soulik.info> writes:
>>> ayaka <ayaka@soulik.info> writes:
>>>>> On 08/13/2016 01:44 AM, Greg KH wrote:
>>>>>> On Sat, Aug 13, 2016 at 12:38:46AM +0800, ayaka wrote:
>>>>>>
>>>>>>> On 08/12/2016 03:40 PM, Greg KH wrote:
>>>>>>>> On Fri, Aug 12, 2016 at 10:23:15AM +0800, ayaka wrote:
>>>>>>>> Hello all:
>>>>>>>> I recently add a support for customize am3358 board using the branch
>>>>>>>> processor-sdk-linux-03.00.00 from Ti git. But I meet a problem with musb
>>>>>>>> at the peripheral mode.
>>>>>>> Then you are going to have to get support from TI for this, nothing we
>>>>>>> can do here about random vendor kernel trees, sorry.
>>>>>>>
>>>>>>> If you can use the 4.7 tree, or better yet, the 4.8-rc tree, then we
>>>>>> I have tried the 4.8-rc1, I meet the same problem.
>>>>> What problem is that exactly?
>>>> Sorry, the USB1 can't work at high speed gadget mode and have DMA problem.
>>>> musb-hdrc musb-hdrc.0.auto: Failed to request rx1.
>>>> musb-hdrc musb-hdrc.0.auto: musb_init_controller failed with status -517
>>> -517 is EPROBE_DEFER. Most likely DMA hasn't probed and MUSB is
>>> deferring to try later. This does _NOT_ MUSB can't work with
>>> DMA. Perhaps you didn't enable support for MUSB's DMA engine.
>>>
>> I have set the status of cppi41dma to okay in dts. And CONFIG_USB_TI_CPPI41_DMA,
>> CONFIG_TI_CPPI41 and CONFIG_TI_EDMA are enabled with build into kernel.
>>
>> Anything else I should do?
> no, that should do it. Since musb returned -EPROBE_DEFER, it will retry
> probing later. Check if musb probed fine. The easiest way is to check if
> you have anything in /sys/class/udc/
Yes, it has musb-hdrc.0.auto. But it doesn't mean that it fallback PIO mode?
Actually I don't care whether it use PIO or DMA, I just can't bear it
work in USB 2.0 Full Speed mode, too slow.
>

\
 
 \ /
  Last update: 2016-09-17 09:57    [W:0.183 / U:0.120 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site