lkml.org 
[lkml]   [2016]   [Nov]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH] ARM: dts: da850: specify the maximum bandwidth for tilcdc
From
Date
On 28/11/16 07:24, Sekhar Nori wrote:
> On Friday 25 November 2016 09:07 PM, Bartosz Golaszewski wrote:
>> It has been determined that the maximum resolution supported correctly
>> by tilcdc rev1 on da850 SoCs is 800x600@60. Due to memory throughput
>> constraints we must filter out higher modes.
>>
>> Specify the max-bandwidth property for the display node for
>> da850-based boards.
>>
>> Signed-off-by: Bartosz Golaszewski <bgolaszewski@baylibre.com>
>> ---
>> arch/arm/boot/dts/da850.dtsi | 1 +
>> 1 file changed, 1 insertion(+)
>>
>> diff --git a/arch/arm/boot/dts/da850.dtsi b/arch/arm/boot/dts/da850.dtsi
>> index 8e30d9b..9b7c444 100644
>> --- a/arch/arm/boot/dts/da850.dtsi
>> +++ b/arch/arm/boot/dts/da850.dtsi
>> @@ -452,6 +452,7 @@
>> compatible = "ti,da850-tilcdc";
>> reg = <0x213000 0x1000>;
>> interrupts = <52>;
>> + max-bandwidth = <28800000>;
>
> If this is effectively the max pixel clock that the device supports,
> then why not use the datasheet specified value of 37.5 MHz (Tc = 26.66 ns).

There's a separate property for max-pixelclock. This one is maximum
pixels per second (which does sound almost the same), but the doc says
it's about the particular memory interface + LCDC combination.

But this 'max-bandwidth' does sound quite odd, as the it really should
be bytes, not pixels... Bad bindings again, which we just have to use.

Tomi

[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2016-11-28 08:44    [W:0.027 / U:0.196 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site