[lkml]   [2016]   [Nov]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH V2] usb: xhci: add support for performing fake doorbell
Hi Mathias,

On 17 October 2016 at 22:30, Rafał Miłecki <> wrote:
> From: Rafał Miłecki <>
> Broadcom's Northstar XHCI controllers seem to need a special start
> procedure to work correctly. There isn't any official documentation of
> this, the problem is that controller doesn't detect any connected
> devices with default setup. Moreover connecting USB device to controller
> that doesn't run properly can cause SoC's watchdog issues.
> A workaround that was successfully tested on multiple devices is to
> perform a fake doorbell. This patch adds code for doing this and enables
> it on BCM4708 family.
> Signed-off-by: Rafał Miłecki <>
> ---
> V2: Enable quirk for brcm,bcm4708 machines instead of adding separated binding
> for it. Thanks Rob for your comment on this.

Do you think you can pick & push this one? V2 follows Rob's suggestion
and he has some DT knowledge for sure, so I guess it should be OK.

 \ /
  Last update: 2016-11-21 08:58    [W:0.071 / U:0.060 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site