Messages in this thread |  | | Date | Mon, 10 Oct 2016 10:13:47 +0100 | From | Russell King - ARM Linux <> | Subject | Re: [PATCH v3 08/12] scsi/ncr5380: Use correct types for device register accessors |
| |
On Mon, Oct 10, 2016 at 12:46:53AM -0400, Finn Thain wrote: > For timeout values adopt unsigned long, which is the type of jiffies etc. > > For chip register values and bit masks pass u8, which is the return type > of readb, inb etc. > > For device register offsets adopt unsigned int, as it is suitable for > adding to base addresses. > > Pass the NCR5380_hostdata pointer to the board-specific routines instead > of the Scsi_Host pointer. The board-specific code is concerned with > hardware and not with SCSI protocol or the mid-layer. > > Signed-off-by: Finn Thain <fthain@telegraphics.com.au> > Reviewed-by: Hannes Reinecke <hare@suse.com> > Tested-by: Ondrej Zary <linux@rainbow-software.org> > Tested-by: Michael Schmitz <schmitzmic@gmail.com> > --- > drivers/scsi/arm/cumana_1.c | 20 +++++++++++--------- > drivers/scsi/arm/oak.c | 6 ++----
For these two:
Acked-by: Russell King <rmk+kernel@armlinux.org.uk>
Thanks.
-- RMK's Patch system: http://www.armlinux.org.uk/developer/patches/ FTTC broadband for 0.8mile line: currently at 9.6Mbps down 400kbps up according to speedtest.net.
|  |